Bearing characteristics and optimal modification coefficient of modified face gear pair
Xuezhong Fu,Zongde Fang,Xiangying Hou,Jianhua Li
DOI: https://doi.org/10.13245/j.hust.170612
2017-01-01
Abstract:To improve meshing performance of face gear pair, the modified face gear was generated by a modified gear shaper cutter.The tooth surface equation and fillet equation of the modified face gear were deduced, and 3D model of modified face gear was obtained, thus establishing the computational models for loaded tooth contact analysis (LTCA) and stresses field analysis of the modified face gear pair.Taking tooth surface contact stresses and bending stresses as two optimized objectives, a multi-objective optimization model was established.Design variables included modification coefficient, and a fast elitist non-dominated sorting genetic algorithm-Ⅱ (NSGA-Ⅱ) was selected as the multi-objective optimization algorithm.The results show that the modification of face gear pairs can affect loaded transmission errors, gear transverse load distribution factors and magnitude of load on the flank of tooth, but the wave amplitude of loaded transmission errors is not sensitive to modification coefficient.Negative addendum modification can increase contact ratio and reduce the bending stresses peak of the modified face gear, increasing the tooth surface contact stresses peak and the bending stresses peak of the modified pinion, whereas positive addendum modification can reduce the tooth surface contact stresses peak and the bending stresses peak of the modified pinion, increasing the bending stresses peak of the modified face gear.The optimized modification coefficient can not only improve the tooth surface contact strength, and can keep both gears′ bending strength the same, then, the bearing capacity of the face gear pair is improved.