Abstract:Identifying bridge damage using a movable test vehicle is highly regarded for its mobility, cost-effectiveness, and broad monitoring coverage. Previous studies have shown that the residual contact-point (CP) response between connected vehicles is free of the impact of vehicle self-vibrations and road roughness, making it particularly suitable for the indirect extraction of bridge modal properties. However, most experimental campaigns regarding contact-point (CP) responses focus on a single-axle testing vehicle within a non-moving state. This study aims to theoretically and experimentally identify bridge damage using the instantaneous amplitude squared (IAS) extracted from the residual CP response of a two-axle passing vehicle. First, the closed-form solution of the residual CP acceleration was derived for a two-axle vehicle interacting with a simply supported beam. The IAS index was constructed from the driving frequency of the residual CP acceleration. Then, numerical investigations using finite element simulation were conducted to validate using the IAS index for indirect bridge damage identification. The application scope of the approach under various vehicle speeds and road roughness grades was examined. Finally, a laboratory vehicle–bridge interaction system was tested to validate the approach. Numerical studies demonstrated that bridge damage could be directly determined by observing the IAS abnormalities, which were baseline-free. The IAS from the residual CP response outperformed the IAS from CP responses in identifying bridge damage. However, it was better to use the IAS when the vehicle speed was no greater than 2 m/s and the grade of the road surface roughness was not high. Laboratory tests showed that it was possible to identify bridge damage using the IAS extracted from the residual CP acceleration under perfect road surfaces. However, it fell short under rough road surfaces. Hence, further experiments are required to fully examine the capacity of the IAS for bridge damage identification in practical applications.

Innovative Bridge Condition Assessment from Dynamic Response of A Passing Vehicle

Identification of a bridge's structural damage and vehicular parameters based on dynamic response sensitivity analysis

Structural damage identification based on dynamic deflection sensitivity of bridge under vehicle loading

Dynamic condition assessment of highway bridges including operational conditions

A Structural Damage Detection Approach Based On Response Sensitivity For Bridges Subjected To Moving Vehicles

Damage Identification of Supporting Structures with a Moving Sensory System

Identification of Distributed Damage in Bridges from Vehicle-Induced Dynamic Responses

Kalman Filter Based Estimation of Neutral Axis Position of Bridge Deck under Traffic Loading

Identification of Both Structural Damages in Bridge Deck and Vehicular Parameters Using Measured Dynamic Responses

Damage Detection in Simply Supported Concrete Bridge Structure under Moving Vehicular Loads

Assessment of Local Damages in Box-Girder Bridges Using Measured Dynamic Responses by Passing Vehicle

Evaluation of the Dynamic Impact of a Passing Vehicle on a Bridge Deck Due to a Damaged Expansion Joint

A Fast Wavelet-Based Bridge Condition Assessment Approach Using Only Moving Vehicle Measurements

Theoretical and Experimental Investigations of Identifying Bridge Damage Using Instantaneous Amplitude Squared Extracted from Vibration Responses of a Two-Axle Passing Vehicle

Damage identification in continuous beam based on dynamic response from moving vehicle loads

Bridge Condition Monitoring under Moving Loads Using Two Sensor Measurements

Mode Shape Identification and Damage Detection of Bridge by Movable Sensory System

An Effective Means for Damage Detection of Bridges Using the Contact-Point Response of a Moving Test Vehicle

Structural damage identification using vibration responses of bridge under vehicles with uncertain parameters

Dynamic Behavior of Damaged Concrete Bridge Structures under Moving Vehicular Loads