Abstract:Good gas permeability is an essential factor for the smooth operation and high performance in the lower part of the blast furnace. Under the present low carbon blast furnace smelting conditions, the coke layer is thinner, and the proportion of the molten metal in the coke layer is significantly higher, resulting in a major reduction in gas permeability, which seriously affects blast furnace operations. Also, the lower thickness of the coke layer weakens the process of solid-liquid carbon dissolution when the molten iron passes through the coke layer, which reduces the carbon content of the molten iron and further deepens the erosion of the refractory by the unsaturated molten iron. The carbon dissolution in the molten iron in a blast furnace core was measured by a high-temperature vacuum wettability test tool that analyzed the interface wetting activity between Fe−C melts with specific carbon mass fraction (3.8%, 4.3%, 4.8%) and 99.9% of high temperatures graphite plates. Besides, the scanning electron microscope (SEM) and energy dispersive spectroscopy (EDS) were used to analyze the graphite substrate’s carburizing morphology and carburizing distances. The results show that, with the increase of carbon content, the interface contact angle becomes bigger. The contact angle decreases with time, and eventually reaches a steady-state during the melting process, and the Fe−C melt with saturated carbon cannot be wet. The scanning electron microscopy analysis shows that a spherical cap-like depression is created by a cross-section of the Fe−C melt and the graphite substrate, and the radius and volume of the depression decrease with increasing carbon content. The study of the EDS scanning analysis shows that the amount of dissolved carbon atoms in the graphite substrate penetrates the Fe−C melt and decreases with increasing initial carbon concentration. The smaller the carburizing effect, the better the wetting is conducive to carbon mass transfer. It is found that by measuring carburizing of the carbon atoms in the graphite substrate into the Fe−C melt by calculating the surface energy reduces the surface energy between the two. Thus, the surface tension decreases and the melt spreads slowly with contact angle gradually decreasing during melting.

Effects of SiO_2/S coating and sulfur phosphorous inhibitor on coking in light naphtha cracking

Influence of the SiO 2/S coating and sulfur/phosphorus-containing coking inhibitor on coke formation during thermal cracking of light naphtha

Investigation into the Anticoking Performances of Sol–Gel-Derived SiO 2 and SiO 2 –CeO 2 Coatings during Thermal Pyrolysis of Light Naphtha

Study on Coking of Endothermic Hydrocarbon Fuelsⅰ Sulf-inhibitor

A study on acceleration and inhibition of coking on metal surfaces by micropyrolysis of ethylene feedstocks

Anti-coking Performance of Al/Si/Cr/Ce Ceramic Coating During Naphtha Steam Cracking Applied on Cr 25 Ni 35 Nb Alloy

STUDY ON COKING OF ENDOTHERMIC HYDROCARBON FUELS Ⅰ.Phosphorous Coking Inhibitor

Preparation and anti-coking application of sol–gel SiO 2 coating in a delayed coking furnace

Carbon Deposition and Sintering Characteristics on Iron-Based Oxygen Carriers in the Catalytic Cracking Process of Coal Tar

Effect of Phosphine on Coke Formation during Steam Cracking of Propane

Interface Wetting Behavior Between Iron and Coke During the Carbon Dissolution Process in a Blast Furnace

EFFECT OF AL(2)O(3) AND SIC CONTENT IN PACK CEMENTATION POWDERS ON THE MICROSTRUCTURE OF SIC COATINGS ON HTR GRAPHITE SPHERES

Effect of coking and propylene adsorption on enhanced stability for Co2+-catalyzed propane dehydrogenation

Investigation on coking deactivation behavior of molecular sieve catalysts

SULFURIZATION OF WATER-SOLUBILITY DISPERSED Ni CATALYST USED IN SLURRY PHASE HYDROCRACKING

Experimental Investigation of the Effects of Inorganic Components on the Supercritical Water Gasification of Semi-Coke

Effects Of Weak Surface Modification On Co/Sio2 Catalyst For Fischer-Tropsch Reaction

Assessment on the effect of unburned pulverized coal on the properties of coke in blast furnace

Product Distribution-Tuned and Excessive Hydrocracking Inhibiting in Fatty Acid Deoxygenation over Amorphous Co@SiO2 Porous Nanorattles

In-situ study of the heating rate effects on covalent bonds conversion and pore/carbon microcrystal evolutions of coal molecule during coking

Pyrolysis and Coking of n-Heptane under Supercritical Conditions