Abstract:Electrochromic devices (ECDs) exhibiting tunable optical and thermal modulation in the infrared (IR) region have attracted extensive attention in recent years due to their attractive application prospects in both military and civilian settings. However, considering the continuous energy supply needed for driving the device operation, it is desired to develop advanced IR-ECDs with low energy consumption. Herein, a flexible self-driven IR-ECD is constructed for achieving variable optical and thermal management in a low-energy mode. In this device, a built-in potential difference of 1.36 V exists between the EC polyaniline cathode and the aluminum foil anode. Consequently, there is a rapid and obvious increase in the IR reflectance of the device after connecting the two electrodes. Such a self-driven reflectance contrast is over 20% at the wavelength of 1500 nm, and the coloration efficiency of the device reaches up to 93.6 cm2 C–1. Meanwhile, the maximum apparent temperature modulation on the surface of the device reaches up to 5.6 °C. Then, the self-driven IR-ECD could recover to its original state driven by a solar cell, indicating good reversibility and stability. We anticipate that this work may provide a new insight into developing advanced self-driven IR-ECDs for applications in dynamic military camouflage and commercial thermal control.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c14123.FTIR spectra of the PANI electrode; CV behaviors of the PANI electrode with different scan rates; cross-sectional SEM images of the PANI electrode with different polymerization charges; CV behaviors of the PANI electrode with different polymerization charges in 2.5–25 μm; IR reflectance of the PANI electrodes with different polymerization charges; the ΔR between colored and bleached states of the PANI electrodes; the reflectance spectra of Au electrodes and PANI electrodes measured at different Au thicknesses; thermal control of the PANI films with different polymerization charges; open-circuit voltage of the self-driven IR-ECD; electrochemical performance of the self-driven IR-ECD; the changes in the structure of the device before and after 100 cycles; optical memory performance of the self-driven IR-ECD; the schematic setup for the measurement of thermal regulation performance of the IR-ECDs; digital photo of the solar panel with a stable voltage output; the comparison of the performance of other NIR-EC films and devices; EC performance of Al-based devices in previous reports; and the ΔR values of the self-driven IR-ECD after different bending cycles (PDF)This article has not yet been cited by other publications.

Adaptive Regulating Means for Driving Current of Infrared Touch Screen

Application of Programmable Gain in Infrared Touch Screen

The design of infrared touch screen based on MCU

30.2: Amorphous Silicon Thin‐Film Transistor Gate Driver Circuit Design with Time Division Driving Method for In‐Cell Touch Display Panel

A Gate Driver Circuit with the Two-Stage Pre-Charge Structure for In-Cell Touch Panels

In-Cell Self-Capacitive-Type Mobile Touch System and Embedded Readout Circuit in Display Driver IC

Robust Bidirectional Gate Driver on Array Based on Indium Gallium Zinc Oxide Thin-Film Transistor for In-Cell Touch Displays

P-2: Integrated a-Si Circuit for Capacitively Coupled Drive Method in TFT-LCDs

Design of AM Self-Capacitive Transparent Touch Panel Based on A-Igzo Thin-Film Transistors

A compact gate driver with bifunctional capacitor for in-cell touch mobile display

Self-Driven Infrared Electrochromic Device with Tunable Optical and Thermal Management

A Low-Computing-Complexity Touch Signal Detection Method and Analog Front-End Circuits Based on Cross-Correlation Technology for Large-Size Touch Panel

A Fully Flexible Intelligent Thermal Touch Panel Based on Intrinsically Plastic Ag 2 S Semiconductor

Wafer level LED drive circuit system

Reducing Power Consumption of Active-Matrix Mini-LED Backlit LCDs by Driving Circuit

The Design of High Precision Temperature Control System for InGaAs Short-wave Infrared Detector

A Fully Flexible Intelligent Thermal Touch Panel Based on Intrinsically Plastic Ag2S Semiconductor

Driving Scheme Optimization for Electrowetting Displays Based on Contact Angle Hysteresis to Achieve Precise Gray-Scales

Adaptive frequency driving scan driver based on a‐InGaZnO TFTs for extremely low‐power displays

Optimizing Multi-Touch Textile and Tactile Skin Sensing Through Circuit Parameter Estimation

Design and Analysis of a Piezoelectric Material Based Touch Screen with Additional Pressure and Its Acceleration Measurement Functions