Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

Dual-wavelength Chaos Generation and Synchronization in Erbium-Doped Fiber Lasers

Generation and Intelligent Synchronization of Photonic Millimeter-wave Chaos

Experimental Investigation on Chaotic Behaviors in Loss-Modulated Erbium-Doped Fiber-Ring Lasers

Dual-wavelength Rectangular Pulse Erbium-Doped Fiber Laser Based on Topological Insulator Saturable Absorber

Broadband chaos generation utilizing a wavelength-tunable monolithically integrated chaotic semiconductor laser subject to optical feedback

Broadband electro-optic chaotic system using coupling mutual feedback for intensity and phase chaos generation

Effect of Coupling Strength on Chaos Synchronization Generated by Erbium-Doped Fiber Ring Laser

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser

Wavelength-Spacing Tunable Multi-Wavelength Erbium-Doped Fiber Laser Incorporating A Semiconductor Optical Amplifier

A multi-wavelength chaotic light source based on a semiconductor optical amplifier fiber ring laser

Semiconductor Laser-Based Multi-Channel Wideband Chaos Generation Using Optoelectronic Hybrid Feedback and Parallel Filtering

Stable Multi-Wavelength Erbium-Doped Fiber Laser by Using Dispersion-Shifted Fiber

Random laser emission at 1064 and 1550 nm in a Er/Yb co-doped fiber-based dual-wavelength random fiber laser

Tunable Chaotic External-Cavity Semiconductor Laser With Time-Delay Signature Suppression Including a Broadband Chirped FBG

Effect of Transmission Fiber on Chaos Communication System Based on Erbium-Doped Fiber Ring Laser

A 100 Mw-Level Single-Mode Switchable Dual-Wavelength Erbium-Doped Fiber Laser

Generation of widely tunable single- and dual-wavelength in a figure-eight mode-locked fiber laser

Broad bandwidth dual-wavelength fiber laser simultaneously delivering stretched pulse and dissipative soliton

Tunable and switchable dual-wavelength Er-doped fiber ring laser using ASEs

Time-delay signature concealed broadband gain-coupled chaotic laser with fiber random grating induced distributed feedback

Tunable and Switchable Six-Wavelength Erbium-Doped Fiber Ring Laser