Abstract:This experimental study was conducted with a heavy-duty diesel engine fuelled with dimethyl ether (DME). The combustion and emission characteristics of DME engine were investigated. The results show that the peaks of in-cylinder pressure, heat release rate (HRR), pressure rise rate (PRR), and mean gas temperature of the DME engine are lower than those of diesel engines. For DME engines, with increase in the engine load, the diagram of HRR varies from two peaks to a single peak. With increasing engine speed under the same mean effective pressure, the ignition timing is delayed, and the heat release centroid gradually moves away from the top death centre (TDC). The DME engine with an injector of six holes and a Plunger of larger diameter exhibits a good performance owing to a faster diffusion combustion. With increase in fuel delivery advance angle at rated power, the ignition timing advances, and the centroid of the HRR is near the TDC. However, the peak of the HRR is at the same level. The results also show that higher torque and power can be achieved with DME than with diesel fuel operation at full load. At full load, the fuel consumption at low engine speeds with DME is lower than with diesel fuel, and nitrogen oxide emissions of the DME engine decrease markedly. Hydrocarbon emissions reduce while carbon monoxide emission slightly increases. The combustion of the DME engine is free of smoke throughout all the operating points. As DME is an oxygenated fuel, its combustion produces less carbon dioxide than that from diesel combustion. European stationary cycle emission test results show that the emissions from the DME engine are below the limits of the Euro 3 regulations.

Performance and emission characteristics of QHCCI dimethyl ether engine

Investigation on Performance and Emission Characteristics of QHCCI DME Engine

Study of HCCI-DI combustion and emissions in a DME engine

Effects of DME Pilot Quantity on the Performance of a DME PCCI-DI Engine

Combustion and Emission Characteristics of a Homogeneous Charge Compression Ignition Engine

Experimental Investigation of DME HCCI Engine Emissions

Study on HCCI Combustion Fueled with DME

Evaluation on the Effects of Compression Ratio, CO2 and LPG on HCCI Combustion Fueled with DME

Evaluation on Effects of Compression Ratio on DME HCCI Combustion Experiments

Study on the performance and emissions of a compression ignition engine fuelled with dimethyl ether

Effects of Compression Ratio and CO2 on the Process of HCCI Combustion Fueled with DME

Study of DME HCCI Engine Emission Characteristic with Different Compression Ratios

Experimental study of effects of exhaust gas recirculation and combustion mode on combustion, emission, and performance of DME‐methanol ‐fueled turbocharged c ommon‐rail engine

Study on Combustion and Emission Characteristics of a Vehicle Engine Fuelled with Dimethyl Ether

Search for the Optimizing Control Method of Compound Charge Compression Ignition (ccci) Combustion in an Engine Fueled with Dimethyl Ether

Experimental Investigation on Combustion Characteristics of DME HCCI Engine

Influences of pilot injection and exhaust gas recirculation (EGR) on combustion and emissions in a HCCI-DI combustion engine

Combustion and Emission Characteristics of a DME (dimethyl Ether)-Diesel Dual Fuel Premixed Charge Compression Ignition Engine with EGR (exhaust Gas Recirculation)

Combustion and performance of heavy-duty diesel engines fuelled with dimethyl ether

Investigation of the Performances of Diesel Engine Fueled with Dimethyl Ether and Vehicle Driving Tests

Study on Combustion Characteristics of Partial Premixed Charge Compression Ignition-Direct Injection Engine Fueled with Dimethyl Ether