Abstract:Ultra-high-rise buildings require high concrete bearing capacity. Ordinary concrete often fails to meet the project requirements. Admixture of admixtures in concrete is a means of solution. Currently, studies on the incorporation of basalt fiber (BF) and fly ash (FA) in concrete are relatively mature. However, research on incorporating nano-Titanium Carbide (nano-TiC) in concrete is still relatively scarce, which has a lot of room for development. To further improve the mechanical properties of concrete, BF, and FA synergized with nano-TiC were incorporated into concrete to produce TBF concrete in this study. And Response Surface Methodology (RSM) was used to optimize the mechanical properties of concrete. The collapse and compressive deformation damage characteristics of concrete were analyzed. The microstructure of the cement matrix was analyzed by the SEM (Scanning Electron Microscope). An optimization model of the TBF concrete craving function was developed. Optimized ratios with compressive, split tensile, and flexural strengths as response objectives were obtained, and the accuracy of the optimized ratios was investigated using the same experimental conditions. The results of the study showed that FA increased the collapse of concrete, while nano-TiC and BF decreased the collapse of concrete. Under uniaxial compression, nano-TiC, FA, and BF together incorporated into concrete can improve its compressive damage state. Moderate amounts of nano-TiC, BF, and FA could improve the mechanical properties of concrete. Their optimal mixing ratio admixtures were 0.88%, 0.24%, and 5.49%, respectively. And the measured values under the same conditions were compared with the predicted values. The maximum difference in compressive strength was 6.09%. The maximum difference in split tensile strength was 7.14%. The maximum difference in flexural strength was 8.45%. This indicated that the accuracy of the RSM optimization model was good. A moderate amount of nano-TiC, FA, and BF could improve the densification of concrete.

Impact on the Properties of Concrete with Fiber and Mineral Admixtures

Admixture in Concrete in the Machanism Research

Influence of Mineral Admixtures on early Shrinkage of Ordinary Concrete

Effects of Mineral Admixture on Properties of Young Concrete

Effects of Mineral Admixtures on Fatigue Behavior of Concrete

Optimal Design and Performance of Concrete with Function Component in Marine Environment

Strength, durability and appearance of low-carbon fair-faced concrete containing multiple mineral admixtures

Mechanical properties and micro-structure analysis of concrete adding high performance composite cementious material

Effects of Blended Steel Slag-Superfine Fly Ash Mineral Admixture and Ordinary Fly Ash on the Properties of Concrete

Experimental Investigation On Mineral Admixture In Improving The Properties Of Concrete To Sulfate Attack

Effects of active mineral admixture on mechanical properties and durability of concrete

THE INFLUENCE OF MINERAL ADMIXTURE ON CONCRETE DURABILITY

Influence Of Composite Effect With Fiber And Fly Ash On Mechanical Properties Of Concrete And Chloride Permeability Of Concrete

Effects of Compound Mineral Admixture on Workability of Concrete

Mechanical Properties and Chloride Penetration Resistance of Concrete Combined with Ground Granulate Blast Furnace Slag and Macro Synthetic Fiber

Effects of Mechanical Properties of Concrete Constituents Including Active Mineral Admixtures on Fatigue Behaviours of High Performance Concrete

Research on mechanical properties of concrete by nano-TiC-BF-fly ash

Performance Analysis of High-Performance Concrete Materials in Civil Construction

Study on the modification effect and mechanism of composite solid waste and steel fiber on the mechanical properties of concrete

Effect of Mineral Admixture on Mechanical Properties of Concrete by Adjusting Interfacial Transition Zone Microstructure