Abstract:Friction is not considered in the calculation of load capacity for spiral bevel gears according to either ISO or AGMA gear standard, and friction effects on the bending, contact and shear of the gears have rarely been discussed. In this regard, the present work establishes analytical solutions to calculate bending and contact strength for spiral bevel gears incorporating friction on the tooth surface, which are verified by ISO gear standard and finite element method (FEM). The bending strength is calculated based on Lewis cantilever beam approximation, utilizing the modified normal force and the friction component. The modified normal force is derived at the highest point of single tooth contact (HPSTC) in the normal equivalent gear. Follow Hertz contact theory, the contact strength is calculated when the modified normal force and the friction component are exerted at the lowest point of single tooth contact (LPSTC) in the normal equivalent gear. The calculated bending and contact stresses agree well with those obtained from the FEM analysis while considering the influence of friction. Both theoretical predictions and FEM analysis have shown that friction has a crucial effect on load capacity of a spiral bevel gear drive, and that it exerts stronger influence on the bending strength (compared with the contact strength). When friction coefficients become larger (with the same input torque), the bending stress considering only the modified normal force decreases at HPSTC, whereas it increases if both the modified normal force and the friction component are included. In comparison, the contact stress will increase at LPSTC under both scenarios. Furthermore, it is illustrated that shear strength check of the tooth is necessary as large friction occurs in the contact zone. This developed analytical solution can be well applied tothe determination of load capacity of spiral bevel gears, especially under harsh working conditions or in the demand for higher performance. (C) 2017 Elsevier Ltd. All rights reserved.

Analysis and Computation for the Clearance of Unsymmetrical Plastic Gear Pair

Analytical Solution to Bending and Contact Strength of Spiral Bevel Gears in Consideration of Friction

APPLICATION OF ASYMMETRICAL PROFILE IN INVOLUTE PLASTIC GEAR

Calculation of the Tooth Face Contact Stress of Asymmetrical Plastic Gear with Analytic Method

Computerized Design and Analysis of Face-Milled, Uniform Tooth Height Spiral Bevel Gear Drives

An Analytic Calculation Method for the Tooth Root Bending Stress of Asymmetric Plastic Gear

Parametric modeling and contact analysis of helical gears with modifications

Design of and research on a noncircular gear with a high-contact-ratio composite tooth profile

Geometric design and analysis of face-gear drive with involute helical pinion

Mathematical design and meshing analysis of a new internal gear transmission based on spatial involute-helix curve

Key Technology and Experimental Study of Unequal Pitches Meshing between Metal Worm and Plastic Helical Gears

A novel forward performance-driven design method for gear parameters

Crossed helical gears—simulative studies and experimental results on non-involute geometries

Computerised design, simulation of meshing and stress analysis of bionic logarithmic spiral spur gear drives

Mismatched gearing composed of hourglass worm and spur gear: Meshing theory, tooth contact simulation, comprehensive design

Mathematic model and tooth contact analysis of a new spiral non-circular bevel gear

Tooth surface geometry optimization of spiral bevel and hypoid gears generated by duplex helical method with circular profile blade

Computerized design and analysis of a novel high load bearing internal gear drive with curved meshing line

Ease-off modification and tooth contact analysis for near net shape face-gear

Analysis of the Partial Axial Load of a Very Thin-Walled Spur-Gear (Flexspline) of a Harmonic Drive

Computerized Design and Generation of Low-Noise Helical Gears with Modified Surface Topology