Abstract:Laser opto-ultrasonic dual (LOUD) detection, which uses laser irradiation of samples to generate spectral and ultrasonic signals simultaneously, can perform multimodal detection of element composition and structural property. As such, it has been applied to the detection of additive manufacturing (AM) components. Further, optimized parameters lead to better detection results. To the best of our knowledge, however, there is no study on the effect of laser properties on LOUD detection. Therefore, we studied the mechanism and influence of laser wavelength and energy on LOUD detection. In this work, the intensity, signal-to-noise ratio (SNR), and stability evolution of the laser excitation spectrum and ultrasonic signals at different wavelengths and energies were analyzed. It was found in the plasma evolution that high electron number density means a large amount of ablated mass generated, which was favorable for laser ultrasonic excitation and can produce higher SNR and a more stable signal. However, it also led to more atoms of the ground-state, which resulted in the self-absorption effect and reduced spectrum intensity in the spectrum analysis. Therefore, with self-absorption correction, better stability, and higher signal intensity, an SNR of spectral and ultrasonic signals can be obtained using 355 nm laser excitation at optimal energy. As a result, in the quantitative analysis of Cu and Si elements by LOUD detection, the determination coefficients (R-2) were higher than 0.995, and the average relative errors were less than 2.5%, the limit of detection could reach the order of 100 ppm. Further, the defect size of 0.55 mm in the wire +arc additive manufacturing sample was detected by LOUD detection, and the average relative error was 5.59% compared with the digital radiography results, which indicate that laser wavelength and laser energy affect the intensity and stability of spectral and ultrasonic signals in LOUD detection, which means selecting appropriate laser parameters is important to obtain a high precision detection. (C) 2020 Optical Society of America

Experiment Research of Acoustic Effect Induced by Pulsed CO2 Laser in Water

ICOPE-15-C063 Photoacoustic Effect in a Single Water Droplet Evaporation Excited by Laser : Analysis of Physical Processes

Coherent OTDR Based Ultra-High Sensitive Acoustic Sensor Assisted with Distributed Microstructured Optical Fiber(DMOF) and Hollow Cylinder Transducer

Underwater Material Recognition Based on Laser-Induced Acoustic Source

Effect of Variable Cross-Section Rod on Laser-Induced Surface Acoustic Waves.

Investigation on Laser Etch-Machining Underwater Based on Thermal-Mechanical Effect

Hybrid optical parametrically-oscillating emitter at 1930 nm for volumetric photoacoustic imaging of water content

Low Repetition Frequency Modulation Method of Optoacoustic Pulses for Underwater Communication

Study of AFM-based probe for detecting laser induced surface acoustic wave

An underwater ranging system based on photoacoustic effect occurring on target surface

Photoacoustic communication system based on detecting laser-generated sound by optical fiber underwater acoustic sensor

Experimental research on ultrasound-assisted underwater femtosecond laser drilling

Research on underwater acoustic detection technology based on optical waveguide resonator cavity

Correlated emission of X-ray and sound from water film irradiated by femtosecond laser pulses

Design and preparation method of fiber optoacoustic effect device used for artificial optical cochlea

Laser Beam Radius Modulation for Linear Optoacoustic Communication

Time-Resolved Force and Schlieren Visualization Study of TEA CO[sub 2] Laser Ablation of Water Droplets

A Pulse Position Demodulation Method for Underwater Optoacoustic Communication Based on Cepstrum-Wavelet Decomposition

Generating acoustic signals of varying intensities via modulating continuous-wave lasers scanning in air

Underwater Wireless Optical Communication Using A Directly Modulated Semiconductor Laser

Investigation Of The Mechanism And Influence Of Laser Wavelength And Energy On Laser Opto-Ultrasonic Dual Detection