Abstract:A high pressure electronic pneumatic pressure reducing valve, consisted of a two-position three-port pilot valve controlled by electromagnet and a piston type main valve, was proposed. The valve used a pressure sensor and a controller to constitute the closed-loop feedback. By consuming a little gas in the pilot valve, rapidity and stability of pressure regulation were preserved, the influences of pilot leakage on the valve and unexpected icing in pilot valve could be avoided. Then the characteristics were analyzed based on the structure and working principle of the valve, finally the simulation model including the vibration of gas supply pressure and load flow rate was built up with AMESim. Simulation results showed that steady pressure reduction could be achieved under the condition of gas supply pressure slowly reducing and load flow rate fluctuating in a big range. When gas supply pressure is 31.5MPa, the output pressure could be steady in 1~30 MPa without adjusting the controller parameters; the influences of machining errors on the valve were also simulated, the results showed that under-lap of pilot spool should be avoided to reduce gas consuming and 10 μm is a suitable choice for the height of annular clearance.

Design of test platform for reliability of pressure regulator based on LabVIEW

Extra-high Pressure Pneumatic Test Bed Based on Virtual Instruments

Design of automatic hydraulic test bench based on LabVIEW

The Pressure Test of Automatic and Centralized Grease Lubrication Systems for Vehicle Chassis

Design of High Pressure Reduction with Expander Pneumatic System' s Controller

Automatic Testing and Control System for Electro-Hydraulic Proportional Displacement Pump Based on LabVIEW

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Pneumatic Resistance Network Analysis and Dimension Optimization of High Pressure Electronic Pneumatic Pressure Reducing Valve

Dynamic Tests for Load-sensitive Multi-way Valve Based on LabVIEW

Development of a novel high pressure electronic pneumatic pressure reducing valve

Design and Development of Test and Control System for Hydraulic Steering Control Unit Based on Virtual Instrument

The Design and Analysis of Multi-Stage Pressure Relief Valve with Hydraulic Resistance Network

The Development of the Static and Dynamic Performance Integrated Test System for Electro-hydraulic Servo Valve

High Pressure Pneumatic Control Valve Performance Test System

Design of gas regulator inspection system based on ARM

Study of engine connecting rod fatigue test system based on NI CompactRIO platform

Design of Pressure Fluctuation Measurement System for Hydro-Turbine Model Test

The Design of Electric Control System of Proportional Electromagnetic Valve Test Bench

The Hydraulic System Design of High Pressure Servo-control Pulse Test Bed

Design of a Spool Valve Overlap Value Pneumatic Measuring System Based on Constant Pressure Control

Design and Experiment of Turbine Model Testing System Based on LabVIEW