The Influence of Heat/pressure Polymerization Method on the Adaptation of Complete Denture Base

Yu-hua Wang,Jian-zhong Zhang,Jing Pan
DOI: https://doi.org/10.3969/j.issn.1006-7248.2006.04.020
2006-01-01
Abstract:PURPOSE:The purpose of this in vitro study is to investigate the mechanical ability and adaptation of complete denture base by the use of thermoformed resin cured with heat/pressure injection method.METHODS:The flexural strength, the surface hardness and the adaptation of thermoformed resin and SR Ivoclar capsule resin were compared between using the conventional water bath-cured method and heat/pressure injection method. The collected date were analyzed statistically using the two-sample t test at alpha=0.05.RESULTS:The thermoformed resin cured with heat/pressure injection method has significant difference from that cured with conventional water bath-cured method on flexural strength and surface hardness (P<0.05). The upper partial base had significant difference in the gap distance at point A, B, D and E (P<0.05) between the thermoformed denture base cured with heat/pressure injection method and conventional water bath-cured method.CONCLUSIONS:These findings indicate that the thermoformed resin cured with heat/pressure injection method has better mechanical abilities and adaptation than that cured with conventional water bath-cured method.
What problem does this paper attempt to address?