Procedure of twin-wire narrow gap MAG welding with one molten pool

Zhao Bo,Fan Chenglei,Yang Chunli,Zhang Liangfeng

DOI: https://doi.org/10.3969/j.issn.1001-1382.2008.01.013

2008-01-01

Abstract:Based on the experiment of twin-wire narrow gap welding in single pool mode by employing alternative pulsed arcs, the influences of welding parameters on the appearance of weld and welding process stability were investigated. The results show that the appearance of weld of twin-wire narrow gap welding in single pool mode is very good. When the wire feeding rate is over 10 m/min, there is no undercut formation of sidewall. With the decreasing of the distance between wires and edge, the welding process stability decreases. In order to maintain the welding stability, the distance between wires and side edges must be greater than 2.5 mm. When the distance between the two wires is increased, the welding process becomes unstable, and even the arc interruption happens. But when the distance between the two wires is less than 10 mm, the welding stability is very good and there is few spatter.