Optimization of photocatalytic oxidation of 2,2′,3,3′-tetrachlorobiphenyl

K.H Wong,S Tao,R Dawson,P.K Wong
DOI: https://doi.org/10.1016/j.jhazmat.2004.03.006
IF: 13.6
2004-01-01
Journal of Hazardous Materials
Abstract:Polychlorinated biphenyls (PCBs) are wide spread environmental pollutants. This research focused the optimum physico-chemical conditions under which photocatalytic oxidation (PCO) can be used to degrade 2,2′,3,3′-tetrachlorobiphenyl (tetra-CB). Among the optimal physico-chemical conditions studied were UV intensity, hydrogen peroxide (H2O2) and titanium dioxide (TiO2) concentrations, initial pH, and possible reaction intermediates were also determined. The results indicate that the optimal physico-chemical conditions necessary for the degradation of tetra-CB by PCO were UV intensity at 3.16mW/cm2, 30mM of H2O2 and 100mg/l of TiO2. In contrast to the results of PCO studies on other organic compounds, the optimum pH for PCO degradation of tetra-CB was 5.5. The removal efficiency was also higher under acidic conditions than alkaline conditions. Although degradation intermediates such as 1,3-bis(1,1-dimethylethyl)benzene, 2,4-bis(1,1-dimethylethyl)phenol, and 3,5-di-tert-butyl-4-hydroxybenzaldehyde were identified at an early stage in the reaction process, they were not completely degraded even after 7h of PCO reaction.
What problem does this paper attempt to address?