Abstract:Asphaltene, the most complex and recalcitrant fraction of heavy oil, was investigated in this study to gain new insights into its structure and reactivity. Two types of asphaltenes, ECT-As and COB-As, were extracted from ethylene cracking tar (ECT) and Canada's oil sands bitumen (COB), respectively, and used as reactants for slurry-phase hydrogenation. Characterization of ECT-As and COB-As was carried out by a combination of techniques, including XRD, elemental analysis, simulated distillation, SEM, TEM, NMR, and FT-IR, to gain insights into their composition and structure. A dispersed MoS<sub>2</sub> nanocatalyst was used to study the reactivity of ECT-As and COB-As under hydrogenation conditions. The results showed that under optimal catalytic conditions, the vacuum residue content of hydrogenation products could be reduced to less than 20%, and the products contained over 50% light components (gasoline and diesel oil), indicating that ECT-As and COB-As were effectively upgraded. The characterization results indicated that ECT-As contained a higher aromatic carbon content, shorter alkyl side chains, fewer heteroatoms, and less highly condensed aromatics than COB-As. The light components (gasoline and diesel oil) of ECT-As hydrogenation products mainly consisted of aromatic compounds with 1-4 rings, with the alkyl chains mainly composed of C1-C2, while light components of COB-As hydrogenation products were mainly composed of aromatic compounds with 1-2 rings and C11-C22 paraffins. The characterization of ECT-As and COB-As and their hydrogenation products revealed that ECT-As was an "archipelago type" asphaltene, composed of multiple small aromatic nuclei interconnected through short alkyl chains, while COB-As was an "island type" asphaltene, with long alkyl chains connected to aromatic nuclei. It is suggested that the structure of asphaltene has a significant impact on both its reactivity and product distribution.

Monodisperse carbon microspheres synthesized from asphaltene

Synthesizing Graphitic Spheres Using Asphaltene-Based Materials by Vacuum Heat Treatment

One-step Syntheses and Properties of Carbon Microspheres with Amino Groups

Controllable synthesis of single-, double- and triple-walled carbon nanotubes from asphalt

Large-scale synthesis and characterization of carbon spheres prepared by direct pyrolysis of hydrocarbons

Mesoscale Aggregation of Sulfur-Rich Asphaltenes: In Situ Microscopy and Coarse-Grained Molecular Simulation

Microscopic mechanism of single-walled carbon nanotubes (SWCNTS) as a dispersant for alleviating asphaltene aggregation

Molecular representation of coal-derived asphaltene based on high resolution mass spectrometry

Slurry-Phase Hydrogenation of Different Asphaltenes to Liquid Fuels on Dispersed MoS 2 Nanocatalysts

Slurry-Phase Hydrogenation of Different Asphaltenes to Liquid Fuels on Dispersed MoS2 Nanocatalysts

Graphitic spheres by pyrolyzing toluene–ferrocene–thiophene in a chemical vapor deposition experiment

Comparison of the composition and structure for coal-derived and petroleum heavy subfraction by an improved separation method

Preparation and Characterization of Mesocarbon Microbeads by the Co-Polycondensation of High-Temperature Coal Tar Pitch and Coal Pyrolytic Extracts

Synthesis of Graphene from Asphaltene Molecules Adsorbed on Vermiculite Layers

Facile and Environmentally Friendly Synthesis of Ultramicroporous Carbon Spheres: A Significant Improvement in CVD Method

The potential occurrence modes of hydrocarbons in asphaltene matrix and its geochemical implications

Influence of Carbon Nanotubes on Morphology of Asphalts Modified with Styrene–Butadiene–Styrene

Carbon Microspheres Prepared by High Internal Phase Emulsion Polymerization

Synthesis of graphene derivatives from asphaltenes and effect of carbonization temperature on their structural parameters

Preparation of Carbon Micro-Spheres by Hydrothermal Treatment of Methylcellulose Sol

Mesoscale Simulation of Asphaltene Aggregation