Effect of Induction Heat Treatment on Microstructure, Mechanical and Corrosion Properties of Stainless Steel 308L Fabricated Using Wire Arc Additive Manufacturing
Yangfan Sun,Xianglong Li,Lai Xu,Hongyao Shen,Yougen Liu
DOI: https://doi.org/10.1038/s41598-024-75382-5
IF: 4.6
2024-01-01
Scientific Reports
Abstract:Induction solution heat treatment can change the mechanical characteristics and corrosion resistance properties of 308 L manufactured via wire arc additive manufacturing (WAAM). Moreover, compare with traditional heat treatment methods, this method can reduce heat treatment time and achieve in-situ local heat treatment. In this paper, in-situ induction heat treatment at 1100 °C for 2, 4, and 6 min were applied on 308 L thin-walled parts produced by WAAM. The result show that ferrite and austenite phase proportions were changed after induction solution heat treatment. Heat treatment at 1100 °C effectively reduced the δ-Fe and σ-Fe content, resulting in a slight decrease in UTS and microhardness, while YS and EL have a certain degree of increase. σ-Fe exhibits a more pronounced strengthening effect than austenite, albeit at the potential expense of steel's elasticity. At the same time, induction heat treatment alters the ferrite to austenite ratio, which also enhances the anti-corrosion properties of the stainless steel. However, the presence of σ-Fe will cause a worsening of the corrosion resistance of the steel. In addition, as the heat treatment progresses, the ferrite's microstructure in the deposition direction undergoes a significant transformation, changing from continuous dendrites to a few equiaxed grains.