Process Integration of Nanofiltration and Foam Separation for Disposal of Waste Water with Low Concentration Ammonium Perfluorooctanoate

南碎飞,王斐,王钦,窦梅
DOI: https://doi.org/10.3321/j.issn:1003-9015.2009.04.029
2009-01-01
Abstract:The traditional way for the disposal of waste water containing low concentration ammonium perfluorooctanoate (APFO) has the defects of high energy consumption,complicate technique and causing secondary contamination. In order to reduce the contamination and recover the APFO from waste water,a process integrating the nanofiltration and foam separation was put forward. In this study,the foam separation was investigated firstly to obtain its optimal operating conditions; and then in combination with the studied nanofiltration results obtained in authors' previous works,the optimal operating conditions for the process integration of nanofiltration and foam separation used for low concentration APFO waste water treatment were proposed. At the APFO concentration of 450 mg·L-1 in waste water,gas flow rate of 35 L·h-1,the ratio of the height of foam and bubbling region of 1.0 and the pH value of 5,the results of the process integration indicate that APFO concentration in the foam overflowing from the foam separation column can reach 3690 mg·L-1,and after nanofiltration,the concentration of APFO in the residual bulk solution is reduced to 37.5 mg·L-1. The advantages of the proposed process integration lie in its mechanical and operational simplicity,high efficiency and low capital and maintenance costs. Furthermore,lower energy consumption can be achieved in comparison with that when nanofiltration and foam separation are used separately.
What problem does this paper attempt to address?