Optimization on Forging Die of Engine Crankshaft and Research on Influence Factors of Wear

SUN Xiaotian,ZHOU Jie,ZHANG Guanghua
DOI: https://doi.org/10.3969/j.issn.1001-3814.2011.05.037
2011-01-01
Abstract:The crankshaft forming process was numerically simulated by DEFORM-3D simulation software.According to the question of crankshaft balance blocke being difficult to fill,through optimizing the flash cavity of the finished forging die,and joining resistance wall structure,the filling ability of billet was improved,the billet could fill mold cavity.The influence of the two factors(forming speed and friction factor) on wear was analyzed under different parameters,the simulation results were consistent with practical experience.
What problem does this paper attempt to address?