Abstract:Simultaneous improvement in strength and ductility has always been a major concern for ferrite/martensite dual-phase (DP) steels. To this end, the synergistic effects of ultrafine grains and nano-size Cu-rich precipitates on the mechanical properties of DP steels were studied using an experimental method combined with first-principles calculations and crystal plasticity (CP) simulations. Ultrafine-grained DP steels consisting of soft ferrite, with an approximately 10% volume fraction of martensite and dispersed nano-sized Cu-rich precipitates, were obtained through warm rolling and subsequent aging heat treatment. Compared to warm deformation with a 50% reduction, that with a 75% reduction leads to finer grains and a higher tensile strength of 976 ± 15 MPa, accompanied by a small loss in elongation due to the aligned connection of the martensite phase, preferred grain orientation distribution, and relatively higher dislocation density. The optimal mechanical properties are a yield strength of 876 ± 13 MPa, tensile strength of 976 ± 15 MPa and total elongation of 15.2%. The CP simulation results indicate that the heterogeneous distribution of martensite leads to strong strain and stress partitioning, thus facilitating early damage nucleation. Additionally, the strengthening effect of precipitation was evaluated based on shearing mechanisms, and the results suggest that the precipitation of nano Cu-rich precipitates contributes to a strengthening of approximately 300 MPa in the steels.

Grain Growth and Hall–Petch Relation in Dual-Sized Ferrite/cementite Steel with Nano-Sized Cementite Particles in a Heterogeneous and Dense Distribution

Grain growth and the Hall-Petch relationship in a high-entropy FeCrNiCoMn alloy

Hall-Petch Relation in a Spheroidized Carbon Steel with Emphasis on the Effect of Intergranular Particles

A Study on the Hall–Petch Relationship and Grain Growth Kinetics in FCC-Structured High/Medium Entropy Alloys

Hall-Petch relationship of interstitial-free steel with a wide grain size range processed by asymmetric rolling and subsequent annealing

Micromechanism involved in ultrafine grained ferrite/martensite dual phase steels strengthened by nanoscale Cu-rich precipitates

A novel method to define the effective average grain size of the materials with lath-typed microstructure: An example of medium manganese steel

Reverse Hall–Petch Effect of Nano-Bainite in a High-Carbon Silicon-Containing Steel

Multi-field Coupled Inverse Hall–Petch Relations for Ferroelectric Nanocrystals

Breaks in the Hall-Petch Relationship after Severe Plastic Deformation of Magnesium, Aluminum, Copper, and Iron

The synergistic effects of ultrafine grains and nano-size Cu-rich precipitates on the mechanical properties of DP steels

Growth Behavior of Ferrite Allotriomorphs Nucleated on Grain Boundary Faces in a Low Carbon Steel

Hall-Petch Strengthening by Grain Boundaries and Annealing Twin Boundaries in Non-Equiatomic Ni2FeCr Medium-Entropy Alloy

Grain size dependent deformation behavior of a metastable Fe40Co20Cr20Mn10Ni10 high-entropy alloy

Plastic Yielding and Tensile Strength of Near-Micrometer Grain Size Pure Iron

Grain growth and Hall-Petch relationship in a refractory HfNbTaZrTi high-entropy alloy

Characterization of strain induced ferrite formed in coarse austenite grained Q235 steel

Hall–Petch relationship in friction stir welds of equal channel angular-pressed aluminium alloys

Normal Hall–Petch behavior of mild steel with submicron grains

Understanding ferrite deformation caused by austenite to martensite transformation in dual phase steels

Effects of Ferrite Grain Characteristics on Strain Distribution of Dual-Phase Steel