Abstract:In a series of batch washing experiments, EDTA solution was used to remediate Cu contaminated soil derived from a Brown Field Site to investigate the removal efficiency of Cu as well as the release characteristics of major elements (Ca, Fe and so forth) by the application of six different EDTA dosages (0.10~6.00 mol/kg). Results showed that, with the increase of EDTA dosage, Cu removal efficiency was enhanced and reached a maximum at 4.00 mol/kg, accompanied by the decrease of Ca releasing and the increase of Fe and Al releasing. When 0.80 mol/kg EDTA was adopted, residual Cu concentration in the washed soil generally complied with the Environmental Quality Standard for Soils (Class III) (GB15618-1995). When calculating the amount of metals washed by per mole EDTA, it was found that the molal ratio of metals to EDTA in the eluate decreased accordingly with the increase of EDTA addition. The maximum molal ratio of Cu/ (K+Na+Ca+Mg+Fe+Al+Mn+Si) was obtained when 0.80 mol/kg EDTA was applied. However, this molal ratio decreased when the EDTA dosage was further increased, indicating that higher EDTA dosages were mainly used for the releasing of other metals. Thus, in this study, 0.80 mol/kg EDTA was considered as the most appropriate dosage which could not only remediate heavy metals contaminated soil to meet the national standard, but also had the best removal efficiency of Cu when compared with other metals. Conclusively, the appropriate EDTA dosages should be determined on the basis of remediation aim, with the total metal removal efficiency and molal ratio of metals to EDTA being taken into account simultaneously.

Desorption Kinetics of Heavy Metals in Medium and Slight Pollution Loaded Soils with EDTA

Kinetics of Heavy Metals Desorption by EDTA and Citric in Contaminated Soil and Their Redistribution of Fractions

Kinetics of Heavy Metals in Medium and Slight Pollution Load Soils under Effects of Citric Washing

Sorption-desorption Dynamic Behavior of Cadmium,Lead with Different Concentrations Combination in Different Metal Burden Soils

Removal of Heavy Metal from Aqueous Solutions Using Chinese Loess Soil

[Sorption-Desorption Behaviors of Cd2+ and Pb2+ in Different Pollution Load Soils].

Desorption of Cu, Zn and Pb from Water Stable Soil Aggregates Separated from Heavy Metal Contaminated Soil Using EDTA

Remediation of Cu-, Zn-, and Pb-Contaminated Soil Using Different Soil Washing Agents: Removal Efficiencies and Mechanisms

Extraction of Heavy Metals from Contaminated Soils with EDTA and Their Redistribution of Fractions

Relations Between Sorption Behavior and Electrokinetic Remediation Effect in Soils Contaminated with Heavy Metals

TOC AND HEAVY METALS DYNAMIC IN CONTAMINATED SOIL SOLUTION AND THEIR CORRELATIONS WITH THE ADDITION OF CHELATING AGENTS

Extraction of Heavy Metals from Water-Stable Soil Aggregates Using Edta

Evaluation of the Extraction Efficiency of Heavy Metals (pb, Cd, Cu) in Soil–Bayberry System

The Changes of Heavy Metals Solubility with Time under Different Chelants in Contaminated Soil

The study of operating variables in soil washing with EDTA.

Washing of Cu contaminated Soil Using EDTA-Removal Efficiency and the Optimization of EDTA Dosage

Impact of Different Extraction Conditions and Different Extracts on Heavy Metals from Several Typical Soils

Kinetics of copper and lead desorption from Lou soil as affected by different desorption agents

Optimization of EDTA Enhanced Soil Washing on Multiple Heavy Metals Removal Using Response Surface Methodology

Fraction Distributions of Lead, Cadmium, Copper, and Zinc in Metal‐Contaminated Soil Before and after Extraction with Disodium Ethylenediaminetetraacetic Acid

Remediation of Heavy Metal Contaminated Soil by Leaching with Na(2)Edta and Stpp