Abstract:Abstract. Changes in engine technologies and after-treatment devices can profoundly alter the chemical composition of the emitted pollutants. To investigate these effects, we characterized the emitted particles' chemical composition of three diesel and four gasoline Euro 5 light-duty vehicles tested at a chassis dynamometer facility. The dominant emitted species was black carbon (BC) with emission factors (EFs) varying from 0.2 to 7.1 mg km−1 for direct-injection gasoline (GDI) vehicles, from 0.02 to 0.14 mg km−1 for port fuel injection (PFI) vehicles, and 0.003 to 0.9 mg km−1 for diesel vehicles. The organic matter (OM) EFs varied from 5 to 103 μg km−1 for GDI gasoline vehicles, from 1 to 8 μg km−1 for PFI vehicles, and between 0.15 and 65 μg km−1 for the diesel vehicles. The first minutes of cold-start cycles contributed the largest PM fraction including BC, OM, and polycyclic aromatic hydrocarbons (PAHs). Using a high-resolution time-of-flight mass spectrometer (HR-ToF-AMS), we identified more than 40 PAHs in both diesel and gasoline exhaust particles including methylated, nitro, oxygenated, and amino PAHs. Particle-bound PAHs were 4 times higher for GDI than for PFI vehicles. For two of the three diesel vehicles the PAH emissions were below the detection limit, but for one, which presented an after-treatment device failure, the average PAHs EF was 2.04 μg km−1, similar to the GDI vehicle's values. During the passive regeneration of the catalysed diesel particulate filter (CDPF) vehicle, we measured particles of diameter around 15 nm mainly composed of ammonium bisulfate. Transmission electron microscopy (TEM) images revealed the presence of ubiquitous metal inclusions in soot particles emitted by the diesel vehicle equipped with a fuel-borne-catalyst diesel particulate filter (FBC-DPF). X-ray photoelectron spectroscopy (XPS) analysis of the particles emitted by the PFI vehicle showed the presence of metallic elements and a disordered soot surface with defects that could have consequences on both chemical reactivity and particle toxicity. Our findings show that different after-treatment technologies have an important effect on the emitted particles' levels and their chemical composition. In addition, this work highlights the importance of particle filter devices' condition and performance.

Heavy Duty Diesel Engine Exhaust Aerosol Particle and Ion Measurements

Nonvolatile ultrafine particles observed to form trimodal size distributions in non-road diesel engine exhaust

Distinguishing fuel and lubricating oil combustion products in diesel engine exhaust particles

Size-resolved Physico-Chemical Characterization of Diesel Exhaust Particles and Efficiency of Exhaust Aftertreatment

Technical note: Emission factors, chemical composition, and morphology of particles emitted from Euro 5 diesel and gasoline light-duty vehicles during transient cycles

The characterisation of diesel exhaust particles – composition, size distribution and partitioning

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

Characterization of Gas and Particulate Phase Organic Emissions (C 9 -C 37 ) from a Diesel Engine and the Effect of Abatement Devices.

Characterization of Gas and Particulate Phase Organic Emissions (C9-C37) from a Diesel Engine and the Effect of Abatement Devices

An Analysis on the Microstructure and Oxidation Characteristics of Particles from Diesel Engine in Exhaust Gas Transport Process

On the Effects of Urea and Water Injection on Particles across the SCR Catalyst in a Heavy - Duty Euro VI Diesel Engine

Methodology of diesel particulate filter testing on test bed for non-road engine application

Roadside Aerosol Study Using Hygroscopic, Organic and Volatility TDMAs: Characterization and Mixing State

Evolution under dark conditions of particles from old and modern diesel vehicles in a new environmental chamber characterized with fresh exhaust emissions

Euro 6 Unregulated Pollutant Characterization and Statistical Analysis of After-Treatment Device and Driving-Condition Impact on Recent Passenger-Car Emissions

Diesel exhaust nanoparticles and their behaviour in the atmosphere.

Study of the Influence of Methanol/f-T Diesel Combustion Particle Materiality Parameters on the Deposition Process in Diesel Particulate Filter Trap Units

An Experimental Study on Particle Evolution in the Exhaust Gas of a Direct Injection SI Engine

Characterization of particulate matter from diesel passenger cars tested on chassis dynamometers

Aerosols In The Exhaust-Gas In Traffic - Reemission Analyzed By Pixe

The investigation of diesel soot emission using instrument combination of multi-wavelength photoacoustic spectroscopy and scanning mobility particle sizer