Experimental study on the effect of freeze–thaw cycles to the cohesion and moisture content of geogrid reinforced silty clay
Rongfei Zhao,Xincheng Liu,Qi Li,Dan Jin,Wei Gao
DOI: https://doi.org/10.1038/s41598-024-68935-1
IF: 4.6
2024-08-26
Scientific Reports
Abstract:The freezing and thawing cycle is one of the primary causes of damage and instability to buildings in seasonal frost regions. During this process, the mechanical properties of soil are affected, leading to settlement, cracking, or deformation of infrastructure. Mitigating or reducing the occurrence of building frost damage in seasonal frost regions has become an important subject of study. Freeze–thaw (F–T) action will influence the distribution of moisture inside the reinforced soil and change the strength of thawing soil, which is closely related to the main influencing factors, such as initial moisture content, compaction degree, reinforced spacing, number of freeze–thaw cycles (FTC), freezing temperature, and effective vertical stress. Cohesion is an important index to determine the shear strength of clay, which is important to analyze the change in cohesion after F–T. Meanwhile, cohesion is closely related to soil moisture content. This study conducted orthogonal experiments on these primary influencing factors (6 factors at 5 levels) through FTC tests, triaxial tests, and moisture content tests to determine the undrained cohesion and moisture content of the clay after FTC, thereby establishing the influence of reinforcement on soil strength under freeze–thaw conditions. Based on the experimental results, SPSS software was used to fit the regression equations of undrained cohesion and moisture content expressed by the main influencing factors at different heights of the clay. Optimization options for the main influencing factors were obtained with Matlab software when the highest undrained cohesion values 6.8, 10.6, 8.9 kPa and lowest moisture content values 24.0%, 24.3%, 26.2% appeared in upper, middle and lower parts of the testing clay structure respectively, in conditions of − 15 °C freezing temperature and 5 times FTC. And determined the optimal combinations of moisture content, reinforcement spacing, compaction density, and vertical load at different heights. Decreasing reinforced spacing in silty clay was beneficial for liquid underwater seepage after F–T. The redistribution of internal moisture in the soil sample strengthened its undrained cohesion, thereby increasing the soil's shear strength. Comparing reinforcement conditions at different locations, it was found that when there were 3 layers of reinforcement with a spacing of 150 mm between them, this spacing was optimal. It played a significant role in improving the soil's shear strength and enhancing its bearing capacity. For reinforced clay itself, the order of the main factors influencing the undrained cohesion of soil after F–T, from high to low, was initial moisture content, reinforced spacing, and compaction degree.
multidisciplinary sciences