Abstract:Amphiphilic azo polymers with different azo chromophores and degree of functionalization (DF) were synthesized, and colloidal spheres of the polymers were prepared by gradual hydrophobic aggregation in selective solvents. To obtain suspensions of colloidal spheres, the required amounts of water were added into the THF solutions at a certain stirring rate. As the water content reached ca. 70 vol%, an excess of water was added into the suspensions to "quench" the formed structures. The obtained suspensions of colloidal spheres were sealed after THF was completely volatilized and were characterized by DLS and UV-Vis spectroscopy. The size and size-distribution of colloidal spheres were measured by using a DLS/SLS-5022F laser light scattering apparatus. Before the measurement, the sample was clarified by a 0.45 mu m Millipore filter to remove dust, and all the DLS measurements were carried out with 90 degrees scattering angle. UV-Vis spectroscopy was used to study the azo chromophore structure variation in the colloid formation process by measuring the parameters such as the trans-to-cis photoisomerization rate and the isomerization degree at the photostationary state. In the photoresponse experiments, the sample was irradiated by a 365 nm UV light source, and the light intensity was 7000 mV/cm(2) at a distance of 38 cm and 21000 mV/cm(2) at a distance of 5 cm. respectively. In our experiment. the sample was 15 cm away from the UV light, and the temperature of the environment was 30 degrees C. The influences of molecular structure and preparation conditions on the size and photoresponsive properties of the colloidal spheres were studied in some detail. The result shows that the functional group type and DF as well as the preparation conditions (initial polymer concentration, the rate of water addition, etc.) have significant effects on the size and photoresponsive properties of the colloidal spheres. The size of colloidal spheres increases with the increase of DF and initial concentration, but decreases with the increase of the rate of water addition. The photoinduced isomerization rate of poly {2-[4-(4-ethoxyphenylazo)phenoxy] ethyl acrylate-co-acrylic acid} (PEAPE) colloids is higher than that of poly {2-[4-(4-cyanophenylazo) phenoxyl ethyl acrylate-co-acrylic acid} (PCNPE) colloids. The PEAPE colloids with higher DF show a slower photoisomerization rate. The photoinduced isomerization rate of the colloids decreases with the increase of initial concentration and the decrease of the rate of water addition. The possible mechanism for the influence is also discussed based on thermodynamics and kinetics consideration. It is believed that the colloidal spheres form through a self-assembling process controlled by the dynamic conditions. For high initial concentration and slow water dropping rate, more polymer chains tend to aggregate on the compact cores formed from the most hydrophobic chains as the water content is above the critical water content (CWC). Moreover, the polymeric chains had chance to rearrange themselves to form stable and compact structures due to the slow rate of water addition. On the other hand, as the rate of water addition increased I the polymeric chains attached to the cores were quickly "frozen" before they could completely adjust their conformations. Also, they could form new less compact cores so as to weaken the continuous aggregation probability. As a result, the formed aggregates had loose structures, and the photoinduced isomerization rate was relatively fast.

Charge Density Effects on the Fluorescence Behavior of Dansyl Labels to Strong Polyelectrolytes

Probing the effects of external species on poly(acrylate acid) chain dynamics by using cationic AIE-active fluorophore

Probing the Ph-Dependent Chain Dynamics of Poly(acrylate Acid) in Concentrated Solution by Using a Cationic AIE Fluorophore

Aggregation-induced emission of an aminated silole: A fluorescence probe for monitoring layer-by-layer self-assembling processes of polyelectrolytes

Data Presenting the Synthesis of Three Novel Stimuli Responsive Hyperbranched Polymers Synthesised Via RAFT Polymerisation and the Bio Conjugation of Folic Acid

A Fluorescent Thermometer Operating in Aggregation-Induced Emission Mechanism: Probing Thermal Transitions of PNIPAM in Water.

Fluorescence Anisotropy Analysis Of Comb-Type Grafted Poly(N,N-Diethylacrylamide-Co-Acrylic Acid)-G-Poly(N,N-Diethylacrylamide) Microgels Labeled By Acenaphthylene

Self-association of hyperbranched poly(sulfone-amine) in water: studies with pyrene-fluorescence probe and fluorescence label

Synthesis and Solution Properties of Fluorocarbon-Modified Poly(N,N-Dimethylacrylamide)

Time-Resolved Fluorescence Study of Aggregation-Induced Emission Enhancement by Restriction of Intramolecular Charge Transfer State

Aggregation induced emission based fluorescence pH and temperature sensors: probing polymer interactions in poly(N-isopropyl acrylamide-co-tetra(phenyl)ethene acrylate)/poly(methacrylic acid) interpenetrating polymer networks

Copolymers of 4-Trimethylsilyl Diphenyl Acetylene and 1-Trimethylsilyl-1-Propyne: Polymer Synthesis and Luminescent Property Adjustment

Charge Distribution in PVDF/PMMA Blends under DC Field

Environment-sensitive labels in multiplex fluorescence analyses of protein-DNA complexes

Fluorescence Spectral Properties of Azo Dye-Doped Polymer Film

Controllable Specific Interactions and Miscibility in Polymer Blends: 3. Non-radiative Energy Transfer Fluorescence Studies

Equilibrium Distribution of Permeants in Polyelectrolyte Microcapsules Filled with Negatively Charged Polyelectrolyte: the Influence of Ionic Strength and Solvent Polarity

Effect of Cross-Linking on Dynamics of Semidilute Copolymer Solutions: Poly(methyl methacrylate-<i>c</i><i>o</i>-7-acryloyloxy-4-methylcoumarin) in Chloroform

Effect of Polymer Host on Aggregation-Induced Enhanced Emission of Fluorescent Optical Brighteners

INFLUENCES OF STRUCTURE AND PREPARATION CONDITIONS ON SIZE AND PHOTORESPONSIVE PROPERTIES OF AMPHIPHILIC AZO POLYMER COLLOIDAL SPHERES

Synthesis and Photophysical Properties of Poly(Ester-Amine) Dendrimers with Focal 4-Amino-n-benzylphthalimide, As Sensitive Media Probes and Switchable Proton Sensors