Abstract:Numerous experimental studies have demonstrated that when the characteristic length of nonuniform plastic deformation of metal materials reaches the micrometer level, the mechanical behavior of the material exhibits a significant size effect. Unlike traditional plasticity theory, strain gradient plasticity theory can effectively describe size effects induced by nonuniform deformation by introducing intrinsic length dimensions. The high-order strain gradient plasticity theory can effectively account for the size effects of materials during the initial yield and subsequent hardening stages. However, the finite element implementation of the theory is relatively complex. Moreover, the low-order strain gradient plasticity theory struggles to explain the size effect of microscale metal materials at the initial yield stage because it overlooks microstructure effects. Considerably, this article considers the stress gradient effect and proposes a low-order strain gradient plastic model capable of describing the size effect throughout the plastic deformation stage. The applicability and effectiveness of the model are verified through comparison with experimental data. Using the torsion of fine copper wire as an example, the contributions of strain gradient and stress gradient effects to the plastic hardening of fine copper wire torsion were quantified, and the evolution of geometrically necessary dislocation density and its spatial distribution characteristics were elucidated. Results indicate that the normalized yield torque of fine copper wire increases with the stress gradient during torsion. However, the strain gradient effect is not significant at <0.05 shear strain. As the torsion angle increases, the plastic strain gradient grows, leading to an increase in the density of geometrically necessary dislocations, and the hardening gradually becomes dominated by the strain gradient effect.

Analysis of Internal Length Scales and Strain Localization for the Four Order Rate Dependent and Gradient-Dependent Model

A Discussion On Internal Length Scales And Strain Localization For Rate Dependent And Gradient-Dependent Model

A Discussion on Internal Length Scales and Strain Localization for Rate Dependent and Gradient-Dependent Model with Second and Fourth Order

Two Dimensions Study of Internal Length Scales for Rate Dependent and Gradient-Dependent Models

Large-deformation Geomechanical Problems Studied by a Shear-Transformation-zone Model Using the Material Point Method

Discussion on Interaction between Different Intrinsic Length Scale Parameters for Material Strain Localization Analysis

Interaction between different internal length scales for strain localisation analysis of single phase materials

Basic Theories for Strain Localization Analysis of Porous Media with Rate Dependent Model

Analysis of Size Effects Based on A Symmetric Lower-Order Gradient Plasticity Model

Influence Factors on the Nonlocal Parameter and Scale Factor in Strain Gradient Nonlocal Biot Theory

Buckling Analyses of Three Characteristic-Lengths Featured Size-Dependent Gradient-Beam with Variational Consistent Higher Order Boundary Conditions

Simulation of localization failure with strain-gradient-enhanced damage mechanics

Material Length Scale of Strain Gradient Plasticity: A Physical Interpretation

Finite element solutions for plane strain mode I crack with strain gradient effects

Lower-order Mechanism-Based Strain Gradient Plastic Model Considering Stress Gradient Effect

Some Theoretical Aspects of Strain Localization Analysis of Multiphase Porous Media with Regularized Constitutive Models

Pragmatic Analysis of Material Instability under Strain Control Loading

A microstructure-dependent Kirchhoff plate model based on a reformulated strain gradient elasticity theory

A Simplified Deformation Gradient Theory and Its Experimental Verification

Strain gradient beam model for dynamics of microscale pipes conveying fluid

Theoretical Analysis and Numerical Simulation of Strain Localization in Nonlocal Plasticity Model