Abstract:A Cu–Ni-based alloy with a high power factor is a commercially utilized metallic thermocouple material. However, the high thermal conductivity has been a major limitation to achieving thermoelectric performance in semiconductor materials. Herein, this work presents a 76.1% reduced thermal conductivity (∼7.7 W m–1 K–1) in Cu70Ni30, which is one of the lowest reported values in the literature. Such suppression of thermal conductivity can be attributed to the varied frequency phonon scattering by the interfacial potential barrier, built from micron-scale defects formed via sintering melt-spun ribbons. However, the defects simultaneously reduce the charge carrier concentration, mobility, and thus the electrical conductivity. The lowest thermal conductivity leads to the highest zT and ZTavg in the sample sintered at 673 K under 15 MPa. The values are 0.24 (@573 K) and 0.15 (323–573 K), respectively, which are 130.3 and 140.0% higher than the values of the pristine counterpart. Our work demonstrates that improved thermoelectric performance in Cu–Ni-based alloys can be obtained by creating various interfacial defects even at micron scales, which paves the way to suppress thermal conductivity largely in metallic thermoelectric materials via melt-spinning (MS) and spark plasma sintering (SPS) synthesis.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.2c00404.Additional EDS mapping images, SEM images, calculated κl and κe of Cu70Ni30-sintered bulks according to the Wiedemann–Franz law, fitting values a and b in eq 2, κl/κT of sintered bulks at 323 and 573 K, and Pisarenko plots (PDF)This article has not yet been cited by other publications.

High-throughput Thermal Conductivity Measurements of Nickel Solid Solutions and the Applicability of the Wiedemann–Franz Law

Thermoelastic Properties of Nickel from Molecular Dynamic Simulations

Thermal conductivity mapping of the Ni–Al system and the beta-NiAl phase in the Ni–Al–Cr system

High-Precision Thermal Conductivity Measurements As A Probe of Polymer/Nanoparticle Interfaces

Validation of the Wiedemann-Franz Law in Solid and Molten Tungsten above 2000 K through Thermal Conductivity Measurements via Steady-State Temperature Differential Radiometry

Thermophysical Properties of Ni-Containing Single-Phase Concentrated Solid Solution Alloys

Experimental Validation of the Interfacial Form of the Wiedemann-Franz Law

Thermal Expansion of Ni3al Intermetallic Compound: Experiment and Simulation

Validation of the Wiedemann-Franz Law in solid and molten tungsten above 2000 K through thermal conductivity measurements via steady state temperature differential radiometry

Composition-dependent Interdiffusivity Matrices in Face Centered Cubic Ni–Al–X (X = Rh and W) Alloys at 1423, 1473 and 1523 K: A High-Throughput Experimental Measurement

A New Model to Describe Composition and Temperature Dependence of Thermal Conductivity for Solution Phases in Binary Alloys

Experimental Investigation and Computer Simulation of Diffusion in Pt-Coated Bulk Ni

Multi-Interface-Induced Thermal Conductivity Reduction and Thermoelectric Performance Improvement in a Cu–Ni Alloy

Thermal conductivity in metallic nanostructures at high temperature: Electrons, phonons, and the Wiedemann-Franz law

Electrical and Thermal Conductivities of Polycrystalline Platinum Nanowires

High-Throughput Determination of Interdiffusivities for Ni-Al-Cr Alloys at 1173 K through a Combination of Diffusion Multiple and Numerical Inverse Method

High-throughput Measurement of the Composition-Dependent Interdiffusivity Matrices in Ni-rich Fcc Ni-Al-Ta Alloys at Elevated Temperatures

Lattice thermal conductivity of disordered NiPd and NiPt alloys

Effect of Electrical Contact Resistance on Measurement of Thermal Conductivity and Wiedemann-Franz Law for Individual Metallic Nanowires.

Experimental Research on Thermal Transport Properties of Crystallized Palladium-Based Alloys

Improved model for the thermal conductivity of binary metallic systems