Novel Method for Increasing Bandwidth of Current Control Loop of Converters

王剑,李永东,马永健

DOI: https://doi.org/10.3969/j.issn.1001-2095.2009.06.009

2009-01-01

Abstract:Generally,power semiconductor devices in high-power converters work at low frequency,i.e.,there is big time delay in the current control loop,which degrades the dynamic and steady-state performance of the current loop.A mathematical model was developed for current loop at first.Then,the proportional and integral(PI) parameters were calculated and the bandwidth of the loop was obtained based on this model.After that,the time sequence was analyzed for the current loop,and it is pointed out that the calculating delay is the major source of delay in the loop.A new time sequence was then proposed,which may eliminate the calculating delay by properly limiting the voltage output of the converter and updating PWM immediately after it is calculated.The bandwidth of the current loop may be 3 times of that with the traditional time sequence.The feasibility of proposed method is verified through experiments.With the increase of microprocessors′ speed,this method will impose less limitation on output voltage and have more widely application.