Abstract:It is difficult to control a surface wetting due to the random surface texture, but its fabrication is easy. Hence, the volume ratio is proposed through the 3D characterization of micro-structured surface in contrast to traditional roughness factor, fractal dimension and aspect ratio through 2D characterization. The objective is to investigate the wetting properties related to the characterization of irregularly microstructured surface. First, the irregularly micro-structured Si surfaces with 0.22-3.58 pin in depth were machined by the rubbing, the polishing and the grinding with different diamond abrasive grain size and random abrasive grain shape, respectively; secondly, the surface wetting properties were investigated with regard to the characterized parameters of measured micro-topographic surfaces; finally, the irregular wetting model was constructed by using volume ratio on the base of non-composite wetting. It is shown that the contact angle increases with increasing roughness factor and aspect ratio and decreasing fractal dimension on the irregularly micro-structured surfaces, but it is different from the prediction of non-composite wetting model. Moreover, the irregularly micro-structured surfaces without anisotropic properties produce smaller contact angles than regularly micro-structured surfaces with anisotropic properties. The experimental results show that an increase in volume ratio leads to a decrease in contact angle. It is identical to the predictions of the proposed model. This is because the volume ratio precisely illustrates 3D contact information between the liquid and solid interfaces. It is confirmed that the volume ratio may be utilized to predict and control the wetting of irregularly micro-structured surface. (C) 2015 Elsevier B.V. All rights reserved.

The Model of Rough Wetting for Hydrophobic Steel Meshes That Mimic Asparagus Setaceus Leaf.

Design of a Superhydrophobic Surface Using Woven Structures

Wetting Behaviours of a Single Droplet on Biomimetic Micro Structured Surfaces

Design and Fabrication of Hydrophobic Copper Mesh with Striking Loading Capacity and Pressure Resistance

Characterization of Irregularly Micro-Structured Surfaces Related to Their Wetting Properties

Bi-Gaussian Stratified Wetting Model on Rough Surfaces.

A New Model for the Formation of Contact Angle and Contact Angle Hysteresis

Wettability of umbrella-like surface arrays inspired by springtail skin microstructure

Drag Reduction of Stable Biomimetic Superhydrophobic Steel Surface by Acid Etching under an Oxygen-Sufficient Environment

Bioinspired Robust Water Repellency in High Humidity by Micro-meter-Scaled Conical Fibers: Toward a Long-Time Underwater Aerobic Reaction

A 3-D Model for Thermodynamic Analysis of Hierarchical Structured Superhydrophobic Surfaces

Study on Controllable Wettability of Roughness Surfaces

3-D Thermodynamic Analysis on Wetting Behavior of Superhydrophobic Surfaces

Biomimetic Surfaces with Hierarchical Structure Using Microsized Texture and Nanosized Cu Particles for Superhydrophobicity

3D thermodynamic analysis of superhydrophobicity of cylinder microtextured surfaces

Droplet rolling angle model of micro-nanostructure superhydrophobic coating surface

Numerical studies of dynamic behavior of liquid film on single-layer wire mesh with different wettabilities

Experimental Investigation on the Droplet Stability of Superhydrophobic Mesh

A three-dimensional model for analyzing the anisotropic wetting behavior of striped surfaces

Estimation of the Structure of Hydrophobic Surfaces Using the Cassie-Baxter Equation

A Facile Method to Fabricate Surfaces Showing Superhydrophilicity in Air and Superhydrophobicity in Oil