Abstract:Four kinds of sterically hindered groups-based hyperbranched polyfluorene copolymers containing different branching units such as benzene or triphenylamine were designed and synthesized.All the monomers such as 2,7-dibromo-9,9-dioctylfluorene,2,7-dibromospiro(fluorene-9,9′-xanthene), 9,9-dioctylfluorene-2,7-bis(4,4,5,5-tetramethyl-1,3,2-dioxaborolane) and 9,9-dioctylfluorene-2-boronic acid were prepared according to the literature procedures.Suzuki polycondensation (SPC) with the branching units and linear units was conducted in biphasic system (toluene/aqueous Na_2CO_3) with Pd(PPh_3)_4 as a catalyst precursor.The reaction mixture containing monomers was kept stirring at 72℃ under nitrogen for 60 h at the polymerization stage.Then,the end-capped group was added to the reaction mixture together with additional Pd(PPh_3)_4 in order to reduce the heavy atom effect which quenched fluorescence.The reaction was continued for further 12 h.After cooling to room temperature,some amount of thiourea was added,and then the mixture was vigorously stirred for another 3 h.The mixture was filtrated to remove the catalyst residues and extracted with toluene.After removal most of the solvent,the crude polymer in certain amount of toluene was added dropwise to methanol and the formed precipitate was recovered by filtration.The solid was washed with methanol,water and again with methanol,then followed by Soxhlet extraction with acetone for 48 h to remove oligomer.The yellow powder was collected and dried under vacuum.All the resulting hyperbranched copolymers are soluble in common organic solvents,such as tetrahydrofuran,chloroform and toluene.The structures of the hyperbranched polymers were fully characterized by NMR,GPC,elementary analysis and thermogravimetric analysis.The degrees of branching of the polymers were calculated through the integration of the characteristic signals of the branching units and linear units from the high-resolution NMR spectroscopy.The GPC experimental results showed that the number-average molecular weights of the polymers were from 11200 to 17200.The thermal degradation temperatures (weight loss 5%) of the polymers were nearly at 400℃.Cyclic voltammetry (CV) was used to assess the electrochemical behavior of the polymers.The polymers show a reversible oxidation/reduction wave which can be assigned to the oxidation/reduction potential of copolymer main chain from the onset.The HOMO level of the polymer containing triphenylamine is lower than that containing benzene,which indicated less difficulty in hole injection.The photophysical characteristics of the polymers were investigated in solution and in solid films.Solid films on quartz plates used for UV-Vis,fluorescence were prepared by spin-coating with 10~ -3 mol/L tetrahydrofuran solution.The absorption maxima of the polymers are blue-shifted within 10 nm compared to that in solution.In addition,the PL maxima remain unchanged or are only slightly red-shifted.Their thermal stability was investigated from the change of fluorescent spectra in solid films after annealing at elevated temperature in air.There was no obvious change in the PL spectra,and no additional green-blue band emission was observed even after the film was annealed at 200℃ in air.Apparently,with the introduction of spirofluorene/large aromatic units to the hyperbranched structure,the red-shifted phenomena and the undesirable low-energy long wavelength emission band are reduced remarkably.All results indicated that the tendency to form aggregate/excimers in the solid state was efficiently suppressed,and the spectral stability of the polymers was greatly improved.

Preparation of Fluorescent Hyperbranched Polymer Materials by End-Capping Approach

Preparation And Characterization Of Fluorescent Hyperbranched Polyether

Stimulus Responsive Fluorescent Hyperbranched Polymers and Their Applications

Hyperbranched conjugated poly(tetraphenylethene): Synthesis, aggregation-induced emission, fluorescent photopatterning, optical limiting and explosive detection

Hyperbranched Polytriazoles: Click Polymerization, Regioisomeric Structure, Light Emission, and Fluorescent Patterning

Hyperbranched Conjugated Polysiloles: Synthesis, Structure, Aggregation-Enhanced Emission, Multicolor Fluorescent Photopatterning, And Superamplified Detection Of Explosives

Hyperbranched Polymer Based on Triphenylamine and Pyridine: Fluorescent Chemosensors for Palladium Ions

A Red-Emitting Cationic Hyperbranched Polymer: Facile Synthesis, Aggregation-Enhanced Emission, Large Stokes Shift, Polarity-Insensitive Fluorescence and Application in Cell Imaging

White Light Emission of Multi-Chromophore Photoluminescent Nanoparticles Using Polyacrylate Scaffold Copolymers with Pendent Polyfluorene Groups

A Universal Strategy for Producing Fluorescent Polymers Based on Designer Hyperbranched Polyethylene Ternary Copolymers

Unprecedented Multicolor Photoluminescence from Hyperbranched Poly(amino ester)s

A Novel Calixarene-containing Hyperbranched Aliphatic Polyester Incorporated with Pendant Europium Complexes

Azobenzene Functionalized Poly(diphenylacetylene): Polymer Synthesis and Tunable Fluorescent Emission

Novel Copolyanhydrides Combining Strong Inherent Fluorescence and a Wide Range of Biodegradability: Synthesis, Characterization and in Vitro Degradation.

Synthesis, characterization and degradation of a novel class of fluorescent poly[l,3-bis(p-carboxyphenoxy) propane: P-(carboxyethylformamido)benzoic anhydride] (P(CPP:CEFB))

Hyperbranched copolymer containing triphenylamine and divinyl bipyridyl units for fluorescent chemosensors

Synthesis of buffer chemical based fluorescent hyperbranched polymers with strong ultraviolet absorption and high fluorescence quantum yield

Synthesis, Characterization and Thermal Stability of Hyperbranched Polyfluorenes Containing Sterically Hindered Groups

Synthesis and Photophysical Properties of a Blue Light-Emitting Hyperbranched Poly(fluorene)

Synthesis and Striking Fluorescence Properties of Hyperbranched Poly(Amido Amine)

Synthesis of Aldehyde‐functionalized Fluorescent Micelles by Self‐assembly of a Hybrid Polymer Constructed by Hyperbranched Conjugated Polymer Core with Aldehyde End groups and Polyethylene Glycol Shell