Adsorption of Cu(II) on Synthetic Fe,Mn,Al-Oxides Minerals and Its Influencing Factors
WANG Shuai,ZHANG Jin-jing,DOU Sen,WANG Yu-jun,XIE Zhong-lei
DOI: https://doi.org/10.3321/j.issn:1672-2043.2008.03.019
2008-01-01
Abstract:Adsorption processes of Cu2+ on synthetic goethite,hematite,δ-MnO2 and bayerite were studied by batch equilibrium at different pH,ionic strength,temperature,Cu2+ concentration and contact time.The results showed that the adsorption of Cu2+ increased with an increase of solution pH from 2 to 8.The threshold pH values of Cu2+ adsorption were 4,5 and 4 for goethite,hematite and bayerite respectively,but,it was not obvious for δ-MnO2.With an increase of ionic strength,the adsorption of Cu2+ increased on goethite and hematite while it decreased on δ-MnO2 and bayerite.The amount adsorbed increased with an increase of the Cu2+ concentration.The Langmuir model was better than the Freundlich and Temkin models for describing the Cu2+ adsorption isotherms.The adsorption processes of Cu2+ were spontaneous and endothermic with higher disorder.The adsorption of Cu2+ could be divided into two stages:rapid and slow adsorption,and the Elovich model can be used to describe the Cu2+ adsorption rate on goethite and δ-MnO2,the dual-constant and parabola model for hematite and the first-order kinetic model for bayerite respectively.The activation energy(E) and the activation thermodynamic parameters(ΔG#,ΔH#,ΔS#) indicated that Cu2+ adsorption had the least energy requirement and the highest adsorption rate on δ-MnO2,while the greatest energy requirement and the lowest adsorption rate were appeared on hematite.In general,the adsorption affinity of these oxides to Cu2+ were in order of δ-MnO2bayeritegoethitehematite.