Abstract:Copper (Cu), as one of the heavy metals widely used in industrial and agricultural activities, has a fundamental role in the pollution of water resources. Therefore, removing Cu from the aqueous solutions is considered an important challenge in the purification of water resources. Thus, in this study, sawdust with a diameter of 260–600 μm was used to remove Cu from the aqueous solutions. At first, sawdust was washed using distilled water and dried at laboratory temperature. Cu absorption experiments in closed conditions were performed based on the central composite design (CCD) model and with a range of initial Cu concentrations equal to 1–25 mgl −1 . The amount of changes for other variables, including pH, time, and amount of sawdust, was equal to 2–10, 5–185 (min), and 5–25 (gl −1 ), respectively. After the completion of each test, the remaining Cu concentration in the solution was measured using atomic absorption, and the percentage of Cu removed was determined from the difference between the initial and final concentrations. The results showed that the CCD model has a favorable ability to predict Cu removal from the aqueous solutions ( R 2 =0.90 and RSME=3.34%). Based on the Pareto analysis, contact time, the amount of sawdust, pH, and the Cu concentration had the most significant effect on removing Cu from the solution. Contact time, amount of sawdust, and pH were directly related, and the amount of dissolved Cu was proportional to the removal of Cu from the solution. Therefore, sawdust is desirable as a natural adsorbent, and the removal efficiency of Cu from solutions with low Cu concentration is very high (94%). In this regard, it is advised to use sawdust in the process of targeting Cu and heavy metals due to its low cost and availability.

[Characteristics of Cu2+ Adsorption by Sawdust].

REMOVAL OF AQUEOUS Cu(II) WITH NATURAL KAOLIN: KINETICS AND EQUILIBRIUM STUDIES

Adsorption Performances for Aqueous Cu(II) onto Chelating Resin Dowex M-4195: Interaction Mechanism Investigation

Dried Biomass of Activated Sludge for Cu2+ Adsorption: Behaviors and Mechanisms

Removal of Cu(Ii) from Aqueous Solution by Adsorption on Chinese Quaternary Loess: Kinetics and Equilibrium Studies

Modeling Cu removal from aqueous solution using sawdust based on response surface methodology

Removal of some heavy metal cations from aqueous solutions by spruce sawdust. II. Adsorption‐desorption through column experiments

Adsorption Kinetics, Equilibrium, and Thermodynamics of Copper From Aqueous Solutions using Silicon Carbide Derived from Rice Waste

Adsorption Behavior and Mechanism of Cu(II) on Activated Firmiana Simplex Leaf

Biosorption Properties of Cu(Ⅱ) Ions from Aqueous Solutions Using Pine Bark

Adsorption of Cu2+ onto chestnut (Castanea mollissima) shells: Equilibrium, kinetics and process design

Adsorptive Removal of Cu2+from Aqueous Solution Using Aerobic Granular Sludge

ADSORPTION BEHAVIORS AND MECHANISMS OF S930 CHELATING RESIN TOWARD Cu(Ⅱ),Pb(Ⅱ) AND Cd(Ⅱ) FROM AQUEOUS MEDIA

High Efficient Removal of Cu(II) by a Chelating Resin from Strong Acidic Solutions: Complex Formation and DFT Certification

ADSORPTION BEHAVIOR OF Cu IN SANDY LOAM AND ITS AFFECTING FACTORS

Characteristics and Kinetics of Cu2+ Adsorption by Dyella Ginsengisoli LA-4

Research on the kinetics and isotherms for Cu~(2+) adsorption on peanut hull

Cu(II)-imprinted Porous Film Adsorbent Cu–PVA–SA Has High Uptake Capacity for Removal of Cu(II) Ions from Aqueous Solution

Synthesis of cubic mesoporous silica SBA16 functionalized with carboxylic acid in a one-pot process for efficient removal of wastewater containing Cu 2+ : Adsorption Isotherms, Kinetics, and Thermodynamics

Competitive Adsorption of Methylene Blue and Cu2+ Onto Citric Acid Modified Pine Sawdust

Removal of Copper(Ii) Ions from Aqueous Solutions Using Natural Kaolinite