Abstract:Photocatalytic oxidation (PCO) of volatile organic compounds (VOCs) is a highly attractive alternative technology for purification and deodorization of indoor air. The main objectives of this study were to demonstrate that a common fluorescent visible light (FVL) lamp can be used to effectively remove by PCO low concentrations of VOCs from slightly contaminated air and to provide some fundamental and technical details on the process. The target VOC was n-butanol, which is a standard reference odorant. Its PCO was studied under a long residence time in a 3.7-L cylindrical reactor with commercial titanium dioxide (TiO2) as the reference photocatalyst and using mostly FVL for illumination. For comparison only, a UV (black) light lamp was used. The gas-phase products were detected and quantified online by gas chromatography (GC). The effects of reactor residence time, of inlet concentration, and of the relative light intensity on the efficiency of the process were also evaluated. At a high n-butanol concentration (0.1 vol %), butanal and propanal were identified as the intermediate products of the process; ethanal appeared when the initial concentration was < or = 850 ppm(v). This indicates that PCO leading to CO2 and H2O is relatively slow and proceeds in a stepwise manner. Although the efficiency of the process with an FVL lamp was significantly lower than when using a UV black light, complete PCO of low concentrations was achieved for 100 ppm(v). In a search for a material with photoactivation extended to higher wavelengths or increased photoactivity, several samples of transition metal- or silver ion-doped (2 atomic %) TiO2 as well as SrTi(1-x-)Fe(x)O3 (x = 0.1 and 0.15) perovskites were included in the study. None of these materials was more active than pure TiO2. The results of this study open new horizons in the area of in door air quality (IAQ) control.

Removal of Air Pollutants by Photocatalysis with Ozone in a Continuous-Flow Reactor

Destruction of toluene by ozone-enhanced photocatalysis: Performance and mechanism

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Photocatalytic Degradation of Low Concentration Formaldehyde and Simultaneous Elimination of Ozone By-Product Using Palladium Modified TiO2 Films under UV254+185nm Irradiation

Vacuum Ultraviolet-Irradiated Photocatalysis: Advanced Process for Toluene Abatement

Photocatalytic ozonation of organic pollutants in wastewater using a flowing through reactor

Photocatalytic destruction of air pollutants with vacuum ultraviolet (VUV) irradiation

Combination of photocatalysis downstream the non-thermal plasma reactor for oxidation of gas-phase toluene.

A comparative study on decomposition of gaseous toluene by O3/UV, TiO2/UV and O3/TiO2/UV

Research on degradation of formaldehyde in aqueous solution by combined photocatalysis and ozonation

Synergetic Effect Between Non-Thermal Plasma and Photocatalytic Oxidation on the Degradation of Gas-Phase Toluene:Role of Ozone

Catalytic oxidation of VOCs over Mn/TiO2/activated carbon under 185 nm VUV irradiation

Abatement of VOCs Mixture of Emerging Concern by VUV-PCO Process: from Lab to Pilot Scale.

Modeling of ternary mixture of VOCs in photocatalytic oxidation reactor for indoor air quality application

Ozone-Enhanced Oxidation of Pcdd/Fs over V2o5-Tio2-Based Catalyst

Performance of an innovative VUV-PCO purifier with nanoporous TiO 2 film for simultaneous elimination of VOCs and by-product ozone in indoor air

Photocatalytic oxidation technology for indoor environment air purification: The state-of-the-art

Photocatalytic Oxidation for Indoor Air Purification: a Literature Review

Kill two birds with one stone: simultaneous removal of volatile organic compounds and ozone secondary pollution by a novel photocatalytic process

Photocatalytic Oxidation of Volatile Organic Compounds Using Fluorescent Visible Light

Time-resolved spectroscopic investigation for the practical application of a photocatalytic air purifier