Comparison of chlorine and chlorine dioxide disinfection in drinking water: Evaluation of disinfection byproduct formation under equal disinfection efficiency
Dongxiao Wang,Xueyao Chen,Jiayi Luo,Peng Shi,Qing Zhou,Aimin Li,Yang Pan
DOI: https://doi.org/10.1016/j.watres.2024.121932
2024-08-15
Abstract:Disinfection efficiency and disinfection byproduct (DBP) formation are two important aspects deserving careful consideration when evaluating different disinfection protocols. However, most of the previous studies on the selection of disinfection methods by comparing DBP formation were carried out under the same initial/residual dose and contact time of different disinfectants, and such a practice may cause overdose or underdose of a certain disinfectant, leading to the inaccurate evaluation of disinfection. In this study, a comprehensive and quantitative comparison of chlorine (Cl2) and chlorine dioxide (ClO2) disinfection was conducted with regard to their DBP formation under equal disinfection efficiency. The microbial inactivation models as well as the Cl2 and ClO2 demand models were developed. On such basis, the integral CT (ICT) values were determined and used as a bridge to connect disinfection efficiency and DBP formation. For 3-log10 and 4-log10 reductions of Pseudomonas aeruginosa, ClO2 had 1.5 and 5.8 times higher inactivation ability than Cl2, respectively. In the premise of equal disinfection efficiency (i.e., the ICT ratios of Cl2 to ClO2 = 1.5 and 5.8), the levels of total organic chlorine, total organic bromine, and total organic halogen formed in the Cl2 disinfection were significantly higher than those formed in the ClO2 disinfection. Among the 35 target aliphatic DBPs, trihalomethanes (THMs) and haloacetic acids (HAAs) were the dominant species formed in both Cl2 and ClO2 disinfection. The total THM levels formed in Cl2 disinfection were 14.6 and 30.3 times higher than those in ClO2 disinfection, respectively. The total HAA levels formed in Cl2 disinfection were 3.5 and 5.4 times higher than those in ClO2 disinfection, respectively. Formation of the target 48 aromatic DBPs was much favored in Cl2 disinfection than that in ClO2 disinfection, and the formation levels was dominated by contact time. This study demonstrated that ClO2 had significant advantages over Cl2, especially at higher microorganism inactivation and lower DBP formation requirements.