The removal characteristic of DBPsFP by potassium permanganate preoxidation during chlorination of Cyclops metabolite
SUN Xing-bin,HU Yang,SONG Bi-yao,NI Hui-shan,YUAN Ting,LI Yan-peng
DOI: https://doi.org/10.3969/j.issn.1000-6923.2015.11.013
2015-01-01
Abstract:During chlorination process, the Cyclops metabolite would produce disinfection by-products. The objective of present study is to investigate the disinfection by-products precursors removal characteristics by potassium permanganate preoxidation under different conditions. The research indicates that: along with the increasing dosage of potassium permanganate (KMnO4), the concentration of 1,1,1-trichloropropanone (1,1,1-TCP), chloral hydrate (CH), chloroform (TCM) content increases, while the concentration of dichloroacetic acid (DCAA) decreases, this index for chloropicrin (TCNM) increases in the first place while decreases after it reaches its peak. In our experiment, when the KMnO4dosage exceeds 5mg/L, CH, TCNM, DCAN, TCAN, DCAA, TCAA and 1,1-DCP would reach their best removal efficiency, which could exceed 72.2%. The optimum preoxidation time is 20minutes. With the prolonged preoxidation time, the concentration of DCAN, DCAA and TCAA decreases, while the same item of TCM and CH changes in the opposite way. The concentration of TCNM, TCAN and 1,1,1-TCP firstly increases and then decreases. On the contrary, the concentration of 1,1-DCP decreases at first and then increases continuously. pH also has a significant impact on removal efficiency. When pH is lower than 7, TCM generation would be restrained. When pH is 7, TCAA would exceed its lowest concentration while 1,1-DCP would exceed its highest concentration. It would contribute to the decrease of 1,1-DCP with pH above 7. And when pH is higher than 7, the concentration of CH, DCAA, DCAN, TCAN, TCNM and 1,1,1-TCP decreases along with the increase of pH. The removal efficiency would reach its highest value of 80% when the pH is 9. With the increase of temperature, the concentration of DCAA, TCAA and TCM increases, while 1,1-DCP, DCAN and 1,1,1-TCP decreases correspondingly. Furthermore, CH firstly increases and then decreases. TCAN shows the opposite trend to CH. By analyzing the removal characteristics of most DBPsFP indicate that the optimum temperature is 30℃.