Abstract:To optimize the configuration of spatial-temporal resources at intersections with mixed traffic flow of passenger cars and heavy vehicles, this paper proposes a set of mixed integer linear programming（MILP） model with aim to maximize the intersection capacity. In the model, different impacts of the locations of permitted lanes on flows of different modes and vehicle turning maneuvers are considered to increase the model applicability. The constrains on the relative setting position of permitted lanes for left-turn, through and right-turn are released. That’s to say, the permitted left-turn lanes don’t have to be on the left of the permitted through lanes, and the permitted through lanes don’t have to be on the left of the right-turn permitted lanes. This may induce some new flow conflicts（potential conflicts） and whether these conflicts exist is affected by the lane channelization scheme. Thus, some constraints are added in the model, among which one is to identify which potential conflicts are arisen with specific lane scheme, the other is to determine these conflicts’ impact on the configuration of temporal resources at intersections. The results from numerical tests show that this impact will change the configuration of spatial-temporal resources at intersections.Compared with the conventional lane-based model, the modified model can significantly improve the intersection maximum capacity while ensure safe flow propagation. The improvement on the intersection maximum capacity increases with the heavy vehicle proportions and the impact of lane location on travel efficiency. But with the increase of the difference of travel efficiencies between heavy vehicles and passenger cars, the improvement first increases and then decreases.

Model of Minimum Distance Between Interchanges on Urban Expressways

Critical Traffic Volume of Traffic Signal Warrant at Major-Minor Intersections

Optimal Distance between On-off Ramps in Urban Freeway

Minimum Time Headway Model by Using Safety Space Headway

Analysis of Traffic Characteristics and Distance Optimization Design between Entrances and Exits of Urban Construction Projects and Adjacent Planar Intersections

Modification of Stop-Wave Model of Urban Expressway

Critical traffic volume of traffic signal warrant under limited priority condition

Analysis of Traffic Operation Characteristics and Calculation Model of the Length of the Connecting Section between Ramp and Intersection

Factors contributing to urban expressway entrance and exit safety

Minimum Cycle Length of Two-Phase Road Intersection

Maximum Delay Model in Short Length Signalized Intersection under Supersaturated Traffic Flow

The Distribution Model of Velocity in Expressway

A Simulation Study for Minimizing Operating Speed Variation of Multilane Highways by Controlling Access

Configuration of Spatial-temporal Resources at Intersections Considering Travel Efficiencies of Mixed Flows

Offset Optimization Based on Queue Length Constraint for Saturated Arterial Intersections

Simulation of the Frontage Road Control Near the Expressway Exit Ramp

Capacity of unsignalized intersection with mixed distribution headway

Traffic flow capacity model for urban expressways

Analysis of safety factors for urban expressways considering the effect of congestion in Shanghai, China

Gap Acceptance Capacity Model for On-Ramp Junction of Urban Freeway

An Analysis of the Interactions between Adjustment Factors of Saturation Flow Rates at Signalized Intersections