Numerical Simulation of Single-Nozzle Jet Impinging Flow and Heat Transfer Process

LI Zhi,DOU Rui-feng,WEN Zhi,LIU Xun-liang,LOU Guo-feng,SU Fu-yong,FENG Xiao-hong,DONG Bin

DOI: https://doi.org/10.3969/j.issn.1001-6988.2011.04.001

2011-01-01

Abstract:The numerical simulation of the single-nozzle gas jet impinging flow and heat transfer process were calculated by three kinds of RNG based on k-ε turbulence models.The comparison with the experimental results indicated that the RNG based on k-ε turbulence models was able to obtain proper results for gas jet impinging flow and heat transfer.Based on this,the further analysis of the distribution of the local Nu and average Nu shown that the nozzle diameter D has little effect on the value of Nu on stagnation point,but the jet impinging height H/D has obvious and complex effects on the Nu number distribution.Taking the maximal average heat transfer as the standard,the higher heat transfer coefficient would be obtained when H/D between 3 to 5.The Re number only affected the value of the Nu number,but had no impact on it's distribution.The Nu number increased rapidly along with the increase of the Re number.At the jet impact point,the Nu number and the average Nu number were in direct proportional to 0.85 power of the Re number.