Abstract:The study presents the low temperature phase transition of compact chains with one end fixed based on the interacting self-avoiding walks (ISAWS) on the square lattice. The simulation is realized by transfer matrix (TM) method. During the tensile process, the average pulling force < F > has an obviously oscillations at T < 0.1, and the oscillations vanishes with the temperature increasing. Since the compact chain has "frozen conformations" like beta-sheets, and when about half a layer has been opened, the average pulling force < F > decreases obviously. The results agree well with the conclusions by Sanjay Kumar et al. The average pulling force < F >, the average free < F > and the phase transition for compact chains adsorbed on the neutral surface and the attractive surface are investigated respectively. During the initial tensile process, in order to overcome the adsorbed surface, the average pulling force < F > has a peak value, and this phenomenon is also explained by the free energy. The adsorbed surface can make the available average pulling force < F > decrease, so that the area of collapsed phase decreases. On the other hand, the average pulling force < F > also influenced by temperature. At the beginning, when the end-to-end distance x < 12, with the influence of excluded volume effects, the average polling force < F > decreases with the temperature. When end-to-end distance 12 <= x <= 16, the average pulling Force < F > keeps a plateau of a constant force around 0.9 with different temperatures. But with the further extension of the compact chain, when the end-to-end distance x > 16, the average pulling force < F > increases with the temperature. This result has already been found by Kumar el al. for the, biopolymers without considering the attractive surface. With considering the influence of excluded volume effects, when the end-to-end distance x is less than the average size of the coil (without force); the compact chain needs a compressing force instead of a pulling force, i.e. when T = 1.0, the end-to-end distance x = 8, the pull-induced force is compressing force, and comparing with the average compressing forces of compact chains adsorbed on neutral Surface and the attractive surface,the adsorbed Surface makes the available average compressing force decreases. These investigations may provide some insights into the phase transition in the force-induced compact chains.

Elastic behavior of short compact chains confined in double parallel boundaries

Elastic Behavior of Adsorbed Polymer Chains.

MECHANICS BEHAVIORS OF ADSORBED THREE-DIMENSIONAL COMPACT CHAINS

Conformational structures and thermodynamic properties of compact polymer chains confined between two parallel plane boundaries

ELASTIC BEHAVIOR OF POLYMER CHAINS CONFINED IN PARALLEL INTERFACES

Adsorption of Short Two-Dimensional Compact Chains

Elastic Behavior of Compact Polymer Chain Transporting Through an Infinite Adsorption Channel

Phase Behavior of a Single Polyethylene Chain Confined Between Two Adsorption Walls Part B Polymer Physics

SEGMENT DENSITY PROFILES OF COMPACT POLYMER CHAINS CONFINED BETWEEN TWO PARALLEL PLANE WALLS

Conformations and dynamics of adsorbed protein-like chains

Elastic Behavior of Short Compact Polymers.

Conformational behavior of short adsorbed polymer chains

Elastic behavior of single polymer chains adsorbed on rough surfaces

Statics and Dynamics of Adsorbed Uniform Star Chains

Elastic behavior of uniform star polymer chains

Statics and Dynamics of Adsorbed Ring Polymer Chains

Free Energy Barrier for Compact Chains Escaping from a Small Sphere

The Phase Behaviors of Adsorbed Polymethylene Chains

Elastic Behavior Of Protein-Like Single Chain

Pull-Induced Phase Transition in Compact Chains

A STEERED MOLECULAR DYNAMICS STUDY ON ELASTIC BEHAVIOR OF POLYETHYLENE CHAINS