Pollutants Migration and Solid Precipitate Characteristics During the Treatment of Concentrated Leachate from Waste Incineration Plant Based on Direct Contact Evaporation Method
Qi Yuan,Yaji Huang,Erbing Qi,Changqi Liu,Xinye Wang,Yongchao Wu
DOI: https://doi.org/10.1007/s11270-023-06702-0
2023-11-25
Water Air & Soil Pollution
Abstract:It was a challenge to deal with the concentrated leachate (CL) produced by membrane treatment technique in the waste incineration. In this study, the characteristics of the condensate and solid precipitation produced from treatment of CL by lab-scale direct contact evaporation system were investigated, and a process for the treatment of CL with no waste produced was put forward. The air was heated by exhaust steam and high temperature flue gas in the waste incineration to 500°C and used for evaporating CL. The results showed that the concentrations of COD, NH 3 -N, and Cl − in the condensate were 17.6 mg/L, 3.1 mg/L, and 40 mg/L at the condition of the volume of hot air = 600 L/h, pH = 7.2, and concentration factor (CF) = 10, which were lower than the limited values in the water quality standard for industry uses (GB/T 19923–2005) in China, and the condensate can be used in circulating cooling water system for supplying water. Solid precipitation consisted of K 2 Ca(SO 4 ) 2 ·H 2 O, NaCl, KNO 3 , and NaNO 3 . CF was not over 10 because a larger amount of CaSO 4 precipitated on the wall of pipe for passing through hot air, which hindered the continuous operation of the evaporation equipment, when CF > 10. Based on thermogravimetric analysis of solid phase precipitation, the most of organic matter in CL were oxidized and decomposed, while inorganic salts were not volatilized when the heating temperature reached about 760°C. The process for the treatment of CL with no waste produced can produce char and inorganic salts such as KCl and NaCl for waste recycling.
environmental sciences,water resources,meteorology & atmospheric sciences