Abstract:Air sparging (AS) is one of the groundwater remediation techniques for remediating volatile organic compounds (VOCs) in saturated soil. However, in spite of the success of air sparging as a remediation technique for the cleanup of contaminated soils, to date, the fundamental mechanisms or the physics of air flow through porous media is not well understood. In this study, centrifugal modeling tests were performed to investigate air flow rates and the evolution of the zone of influence during the air sparging under various g-levels. The test results show that with the increase in sparging pressure the mass flow rate of the air sparging volume increases. The air mass flow rate increases linearly with the effective sparging pressure ratio, which is the difference between sparging pressure and hydrostatic pressure normalized with respect to the effective overburden pressure at the sparging point. Also the slope of mass flow rate with effective sparging pressure ratio increases with higher g-levels. This variation of the slope of mass flow rate of air sparging volume versus effective sparging pressure ratio, M, is linear with g-level confirming that the air flow through soil for a given effective sparging pressure ratio only depends on the g-level. The test results also show that with increasing sparging pressure, the zone of influence (ZOI), which consists of the width at the tip of the cone or lateral intrusion and the cone angle, will lead to an increase in both lateral intrusion and the cone angle. With a further increase in air injection pressure, the cone angle reaches a constant value while the lateral intrusion becomes the main contributor to the enlargement of the ZOI. However, beyond a certain value of effective sparging pressure ratio, there is no further enlargement of the ZOI.

Development of test device with air sparging technique for geotechnical centrifuge and its test

Development of Centrifuge for Multi-Parameter Combined Environmental Test

Newly Developed Multifunction Device for Consolidation, Permeability and Gas-Injection Tests

Centrifuge Modeling of Air-Sparging Technique for Groundwater Remediation

Centrifuge Modeling and Numerical Simulation of Air Sparging Process

Development of a small-scale geotechnical centrifuge

Development of a Large Geotechnical Centrifuge at Zhejiang University

Gas Injection Test of Remolded Saturated Soil with Consolidation

Study of Flow Transitions during Air Sparging Using the Geotechnical Centrifuge

Development of Geotechnical Centrifuge ZJU400 and Performance Assessment of Its Shaking Table System

Parallel tests on preparation of samples with sand pourer

In-Flight Simulation of the Excavation of Foundation Pit in Centrifuge Model Tests

A centrifuge modelling setup for dewatering, rewetting, and characterizing soil deposits

Physical Modeling of Air-Sparging Technique for Groundwater Remediation

Centrifugal study of zone of influence during air-sparging.

Application of Geotechnical Centrifuges in Geotechnical Engineering Education

Development of Centrifuge Model Test Facility of Retaining Wall

Centrifuge Modeling of Removing Volatile Contaminants in Soils

Centrifuge modeling and numerical simulation of soil contamination and remediation

Development and Application of a Slope Excavation Device for Centrifugal Model Tests

Design of Pressure Retention and Transfer System for Abyssal Sediments