Accident Consequence Analysis of Toxic Gas Leak in Different Release Modes

朱红亚,王青松,李一帆,孙金华
DOI: https://doi.org/10.3969/j.issn.1009-6094.2012.06.047
2012-01-01
Abstract:To investigate the influenced area of hydrogen chloride release and dispersion in different release modes,tank and pipeline release were simulated with ALOHA based on heavy gas model of DEGADIS.It can be found that hydrogen chloride concentration is decreasing with the increasing distance for the three tank release modes which including continuous release through small opening,release through big opening as well as instantaneous release at the same condition of leakage quantity and meteorology.The instantaneous release mode exhibits maximum influenced distances including the downwind distance and crosswind distance and also maximum influenced areas which including the dead area,serious injured area and slight injured area.It shows the fastest dispersion speed if compared to other two modes.Furthermore,the variations of the indoor and outdoor concentration with the dispersion time at the same location are different for the three tank release modes.In the mode of continuous release through small opening,the outdoor concentration increases to the maximum value and then roughly stays at the same level with little decrease,while the indoor concentration is always increasing with the time.In the modes of release through big opening and instantaneous release,the outdoor concentrations for both cases increase to the maximum value first,and then decrease promptly to zero after the transmission of hydrogen chloride vapor cloud moves towards the downwind direction.However,the indoor concentrations for both conditions present an increasing trend up to the maximum value.For the pipeline release modes,the influenced area of infinite source release mode is larger than that of limited source release mode,but it does not follow a linear function with leakage quantity.The results of simulation in the infinite source pipeline release mode and the limited source release mode are similar with that of continuous tank release mode through small opening and big opening,respectively.Through the comparison,it can be concluded that the tank instantaneous release mode and pipeline infinite source release mode exhibit bigger hazardous area than other modes.
What problem does this paper attempt to address?