Modal Separation Before Dispersion Curve Extraction by Masw Method

Julian Ivanov,Choon B. Park,Richard D. Miller,Jianghai Xia,Randy Overton

DOI: https://doi.org/10.3997/2214-4609-pdb.192.ssm_3

2001-01-01

Abstract:Accurate extraction of dispersion curves is the most critical part with any surface-wave method.Although a multichannel method like Multichannel Analysis of Surface Waves (MASW) method provesmost effective for this purpose, there are several acquisition parameters that need to be set properly forthe optimal extraction. One of them requires a long range of receiver spread to separate phase velocity ofone mode from those of other modes. Sometime, however, this requirement can not be met due to an unacceptablelateral inhomogeneity in the near-surface materials being surveyed and therefore multichannelrecords are often collected with a relatively short spread length. In this case the interferencebetween the different modes of surface waves can be so severe that neither fundamental nor highermodedispersion curve can be extracted with a reliable confidence. In addition to this multimodal effectby surface waves, other types of seismic event such as channel (guided) waves can cause similar harmfuleffect during the analysis. When this occurs, a simple multichannel processing technique that mutesthe interfering wavefields in the offset-time (x-t) domain can significantly enhance the resolution ofmultimodal dispersion curves. This is demonstrated by using both synthetic and real shot gathers.