Abstract:ABSTRACT The suspension is a very important subsystem of a vehicle as it affects both passenger ride comfort and the handling properties of the vehicle. This paper concentrates on two important aspects of suspension system design. One is the fine tuning of a passive suspension system design through an optimisation study using a virtual suspension system model. The second is the design and testing of an active suspension controller. Both problems are treated here in a computer aided setting using a highly realistic suspension system and a full vehicle model, respectively. INTRODUCTION The main reason for the existence of a suspension system like that shown in Figure 1 can be thought of as isolating the driver and passengers of a vehicle from the vibrations induced by road irregularities. This, however, is not the only reason for the use of a suspension system. According to Bastow and Howard (1993), maintaining contact between the wheels and the road surface is a far more fundamental issue as the vehicle's control and stability depends on it. So, suspension design requires concentration not only on ride comfort but also on handling characteristics. As ride and handling requirements are in conflict with each other, the design of suspension system characteristics like effective stiffness and damping require the determination of a compromise solution. While the well known quarter car model and higher order lumped parameter models used to represent the vehicle's overall suspension system are useful for preliminary work and initial design, suspension design work of any practical use has to take into account the physical details of the suspension system being used (double wishbone or McPherson strut type for example). While academic optimisation studies on suspension design and active suspension controller design can concentrate on the quarter car model (Cole, 2001; Yagiz and Yuksek, 2001), one needs to base these optimisation and controller design studies on a much more accurate model of the vehicle's suspension system to be able to transfer the results to the automotive industry. Fortunately, such accurate models are quite readily implementable in the form of canned multibody dynamics programs like Adams® (Anon., 2001) and Simpack (Kortum) or special purpose vehicle dynamics programs like Vedyna (Anon., 2000). The latter approach is taken in this paper. The suspension systems used are highly realistic models formed in Adams/Car® (Anon., 2001). This paper focuses on optimisation of suspension parameters and ride and handling properties and on implementation of active suspension control using an Adams/Car® suspension model. A first step in a suspension optimisation study is to determine which suspension variables can be varied and their

Optimization and Matching of Mini Passenger Car Suspension Parameters Based on Design of Experiment

Multi-objective and Multi-criteria Decision Optimization of Automobile Suspension Parameters

Parameters optimization of interconnected hydro-pneumatic suspension for road comfort and road-friendliness based on genetic algorithm

Multi-objective optimization study of vehicle suspension based on minimum time handling and stability

Calculation of Suspension Systems Match for a Motor Car

Optimization and testing of suspension system of electric mini off-road vehicles

Matching Analysis and Optimization of Passenger Car Suspension’s Hydrobushing

Vehicle Ride Comfort Analysis and Optimization Using Design of Experiment

Optimization of heavy truck suspension system based on ride comfort and road friendliness

Experimental and Simulation Study on Vehicle Ride Comfort and Parameter Optimization

Optimization of structural parameters through objective-evaluation of ride comfort in a heavy-duty commercial vehicle

Optimization on Suspension Parameters for the Ride Comfort and Road Friendliness of Commercial Vehicle

Optimization of Vehicle Suspension Parameters Based on Comfort and Tyre Dynamic Load

Matching and optimization of heavy commercial vehicle cab air suspension system

Research on Modeling and Optimization Simulation Analysis of Micro Electric Vehicle Suspension

Multi-objective optimization and experimental investigation of quarter car suspension system

Robust Design Optimization of the Automotive McPherson Suspension Based on Taguchi Method

Multi-objective optimization of the suspension system parameters of a full vehicle model

USE OF COMPUTER AIDED METHODS FOR OPTIMISATION IN VEHICLE SUSPENSION DESIGN AND FOR DESIGNING ACTIVE SUSPENSIONS

Serial combinational optimization method for double wishbone suspension’s pseudo damage improvement

Application of Multi-Objective Optimization Methods to Geometric Design of Suspension