Abstract:The addition of a spark plug in place of the original fuel injector and fumigating natural gas (NG) inside the intake manifold is an economical way to convert heavy-duty diesel engines to NG sparkignition (SI) operation. The literature shows that, when compared to a conventional SI engine combustion chamber, the different in-cylinder flow motion, turbulence intensity distribution, and interaction of propagating flame with chamber boundaries in these converted engines produce distinctive combustion stages. As the current understanding of how these combustion stages affect the engine performance is limited, this study used a triple-Wiebe combustion model to determine the effect of spark timing (ST) on the phasing and mass fraction of each combustion stage, at lean operation (phi = 0.73) and low engine speed (N = 900 rpm). Specifically, the first Wiebe function was associated with the fast burn inside the piston bowl, the second Wiebe function was related to the slower burning process inside the squish region, and the third Wiebe function described the late oxidation of the fuel trapped inside the various crevices. The results show that advancing the ST advanced the combustion phasing of the bowl and squish burn stages, but not the end of the squish burn. Further, there was an overlap between the bowl burn and squish burn, irrespective of the ST, but advancing the ST reduced the overlap and increased the fuel fraction consumed inside the squish. As a larger fraction of fuel burning inside the squish under less optimal conditions would affect the engine efficiency and emissions, a combustion model, such as the one presented in this work, can provide key information for heavy-duty NG engine development and optimization if the phasing and the fraction of the total energy released during each combustion stage are known.

Control and Experiment of the Start and Idle of Lean-Burn Natural Gas Engine

Experimental Investigation of a Heavy-Duty Compression-Ignition Engine Retrofitted to Natural Gas Spark-Ignition Operation

Effect of Spark Timing on the Combustion Stages Seen in a Heavy-Duty Compression-Ignition Engine Retrofitted to Natural Gas Spark-Ignition Operation

Numerical Investigation of Methane Number and Wobbe Index Effects in Lean-Burn Natural Gas Spark-Ignition Combustion

Lessons from the Conversion of a Heavy-Duty Compression Ignition Engine to Natural Gas Spark Ignition Operation

Experimental Investigation of a Heavy-Duty CI Engine Retrofitted to Natural Gas SI Operation

Limitations of Natural Gas Lean Burn Spark Ignition Engines Derived from Compression Ignition Engines

Methodology to Determine the Fast Burn Period Inside a Heavy-Duty Diesel Engine Converted to Natural Gas Lean-Burn Spark Ignition Operation

Methodology to Separate the Two Burn Stages of Natural-Gas Lean Premixed-Combustion Inside a Diesel Geometry

Conversion of a Heavy-Duty Diesel Engine to Natural-Gas Spark-Ignition Operation: Test Bench Development

An Experimental Study of the Combustion Process in a Natural-Gas Spark-Ignition Engine

Starting Control Strategy and Experimental Study of CNG Engine

Influences of the Control Parameters and Spark Plug Configurations on the Performance of a Natural Gas Spark-Ignition Engine

Steady Condition Calibration of Turbocharged Lean Burn HCNG Engine

Impact of Excess Air Ratio and Ignition Timing on CNG Engine Emissions

Optimal control of oil-gas switch process of CNG/diesel dual fuel engine

Development and Calibration on an Electronic Control System of CNG Engine

Design of Hydrogen Enriched Compressed Natural Gas Engine Fuel System and Test Research

Experimental Study of Combustion Strategy for Jet Ignition on a Natural Gas Engine

Numerical Simulation of HCNG Engine on GT-Power

Feasibility Research of Developing Low Power Compressed Natural Gas Engine