Abstract:OBJECTIVE:To compare the bonding durability of three different self-etch adhesives to primary enamel and dentin, and to investigate the effect of mild salivary contamination followed by air drying on the bonding durability.METHODS:Two hundred and forty enamel specimens were divided randomly into 16 groups (n=15/group)according to the adhesive system [self-etch adhesives: Clearfil SE Bond(SE), AdperTM Easy One (EO), Scotchbond Universal (SBU); total-etch adhesive: AdperTM Single Bond Plus(SL)], contamination status (non-contaminated vs. salivary-contaminated) and storage condition (stored in distilled water for 24 h vs. aging mode 5 000 thermal cycles in 5 ℃ and 55 ℃). Two hundred and forty dentin specimens were assigned in the same way. Shear bond strength for 12 specimens in each group were measured. The adhesive interface for the residual specimens in each group was observed by scanning electron microscopy(SEM). Data were analyzed by three-way analysis of variance and Tukey test(P < 0.05).RESULTS:For primary enamel, total-etch adhesive showed higher initial shear bond strength values (28.92±1.83) MPa and shear bond strength values (27.27±3.03) MPa after thermal cycles compared with the other groups, and the difference between the groups was statistically significant (P < 0.01). Shear bond strength values of EO decreased significantly in salivary-treated groups, regardless of storage conditions, and the difference was statistically significant (P < 0.01). For primary dentin, shear bond strength values of EO decreased significantly in salivary-treated groups after 24 h (P < 0.01). After 5 000 thermal cycles, total-etch adhesive showed significantly lower shear bond strength values (14.31±1.97) MPa compared with the other groups, and the difference between the groups was statistically significant (P < 0.01), and shear bond strength values of EO were significantly lower than those in SE and SBU groups (P < 0.01), regardless of contamination status.CONCLUSION:Total-etch adhesive SL has better bonding durability to primary enamel. SE and SBU have better bonding durability to primary dentin and have a certain resistance to salivary contamination, while the bonding performance of EO is compromised greatly by mild salivary contamination followed by air drying.

Evaluate of Shear Bonding Strength of a Self-Etching Adhesive to Dentine in Different Conditions

Evaluation of shear bond strength of self-etching adhesive systems to enamel in different conditions

Influence of Casein Phosphopeptide-Amorphous Calcium Phosphate Application, Smear Layer Removal, and Storage Time on Resin-Dentin Bonding

[Evaluation of Shear Bond Strengths of Self-Etching and Total-Etching Dental Adhesives to Enamel and Dentin].

Evaluate the Shear Bond Strength of Self-Etching Bonding Systems Covered with Temporary Cements

Bonding Effectiveness of the Universal Adhesive on Caries-Affected Dentin of Deciduous Teeth

[Effects of Three Self-Etch Adhesives and Mild Salivary Contamination on the Bonding Durability of Deciduous Teeth].

Determinations of the Bonding Strength with Pressure in the Same Direction for Two Enamel Adhesion Techniques: Self-Etching and All-Etching

Comparison of shear bond strength of four adhesives in dentin

The Effect of Different Pre-Treatments on the Enamel Bonding Properties of a Self-Adhesive Resin Cement

The Comparative Study of the Shear Bond Strength of Two Adhesives

Influence of operator variability on shear bond strength of self-etch adhesive to enamel with and without prior acid-etching

The Effect of Treating Time on the Shear Bond Strength of the Seventh Generation of Adhesive

Comparison of microtensile bonding strength of total-etch and self-etch adhesives

Microtensile Bond Strength of Total-etch and Self-etch Adhesives to Different Dentin

Shear Bond Strength of All-Ceramic Cement to Dentin

Comparative evaluation of bonding performance between universal and self-etch adhesives: In vitro study

Comparison of the bond strength of four self-etching adhesives bounded to normal dentin and caries-affected dentine

Microtensile bond strength and SEM evaluation of total-etch and self-etching adhesives to caries-affected dentine

Effect of Acid Etching Time on Dentin Bond Strength of 4 Total-Etching Adhesives

Bond Strength Evaluation of a Self-Adhesive Composite Resin Cement in Vitro