Preparation and Characterization of Type Ii Anion Exchange Membranes from Poly(2,6-Dimethyl-1,4-Phenylene Oxide) (Ppo)

Tongwen Xu,Zhaoming Liu,Yuan Li,Weihua Yang
DOI: https://doi.org/10.1016/j.memsci.2008.04.006
IF: 9.5
2008-01-01
Journal of Membrane Science
Abstract:To separate hydrophilic anions from hydrophobic ones, Type II PPO-based anion exchange membranes were developed. Different from Type I (with both trimethylbenzylammonium and triethylbenzylammonium groups), Type II has an excellent hydrophobicity modifier as fixed groups: dimethyethanolammonium groups, which were introduced into PPO (poly(2,6-dimethyl-1,4-phenylene oxide)) by following benzyl bromination of PPO and subsequent quaternary amination with a dimethylethanolamine (DMEA) aqueous solution. The membrane's intrinsic properties are dependent on DMEA concentration and amination temperature. The optimum conditions for membrane preparation are as follows: amination temperature 70°C, time 30–48h, and DMEA concentration 1:3–1:5 (v/v, DMEA to water). The obtained Type II anion exchange membranes had an IEC of 1.5mmol/g dry membrane, water content of 30%, and membrane area resistance of 30Ωcm2. The introduced dimethyethanolammonium groups can block hydrated anions from the access to membranes but let hydrophobic anions transport; hence, an effective separation between hydrophilic and hydrophobic anions can be achieved during electro-membrane operation.
What problem does this paper attempt to address?