Abstract:The strong coupling interactions of non-equilibrium flow, microscopic particle collisions and radiative transitions within the shock layer of hypersonic atmospheric re-entry vehicles makes accurate prediction of the aerothermodynamics challenging. Therefore, in this study a self-consistent non-equilibrium flow, collisional–radiative reactions and radiative transfer fully coupled model are established to study the non-equilibrium characteristics of the flow field and radiation of vehicle atmospheric re-entry. The comparison of the present calculation results with flight data of FIRE II and previous results in the literature shows a reasonable agreement. The thermal, chemical and excited energy level non-equilibrium phenomena are obtained and analysed for the different FIRE II trajectory points, which form the critical basis for studying the heat transfer and radiation. The non-equilibrium distribution of excited energy levels significantly exists in the post-shock and near-wall regions due to the rapid vibrational dissociation and electronic under-excitation, as well as the wall catalytic reactions. The analysis of stagnation-point heating of FIRE II illustrates that the translational–rotational convection and the dissociation component diffusion play key roles in the aerodynamic heating of the wall region. The spectrally resolved radiative intensity in the entire flow field indicates that the vacuum ultraviolet radiation caused by the high-energy nitrogen atomic spectral lines makes the main contribution to the radiative transfer. Finally, it is found that the non-equilibrium flow–radiation coupling effect can exacerbate the excited energy level non-equilibrium, and further affect the gas radiative properties and radiative transfer. This fully coupled study provides an effective method for reasonable prediction of atmospheric re-entry flow and radiation fields.

Nonlinear dynamic modeling and simulation of an atmospheric re-entry spacecraft

Computational Simulation of Reentry Flows over Hypersonic Vehicles Using Nonlinear Coupled Constitutive Relations

Numerical Simulation of Weakly Ionized Dynamic Plasma for Reentry Vehicles

Numerical Investigation of Dynamic Properties of Plasma Sheath with Pitching Motion

Numerical Simulation of Sloshing in the Propellant Tank of Reusable Rocket Vehicle Using Meshfree Method

Re-entry vehicle autopilot design using dynamic inversion with L1 adaptive control augmentation

Gaussian Distribution-Based Control Vector Parameterization Method for Constrained Hypersonic Vehicle Reentry Trajectory Optimization

Flow Field Radiation Characteristics Extraction and Analysis of the Re-Entry Orbital Test Vehicle

Data-driven modeling of hypersonic reentry flow with heat and mass transfer

Numerical study on the non-equilibrium characteristics of high-speed atmospheric re-entry flow and radiation of aircraft based on fully coupled model

Aeroelastic Characteristics of Inflatable Reentry Vehicle in Transonic and Supersonic Regions

Study on the aerodynamic characteristics of reentry capsule with obtuse head inverted cone under hypersonic chemical nonequilibrium flow

Modeling and Simulation of Radiation from Electronic Transitions in Hypersonic Atmospheric Reentry Flow

Debris Reentry and Ablation Prediction and Ground Risk Assessment Software System

Extended validation of a ground-based three-axis spacecraft simulator model

Neural Network-based Hardware-in-the-loop Implementation of Fourier Series Parametrized Control Profiles for Re-entry Vehicles

Optimization of Mechanical Deployable Reentry Vehicle based on Multi-Fidelity Aerodynamic-Trajectory Coupling Model

Composite Design of Disturbance Observer and Reentry Attitude Controller: An Enhanced Finite-time Technique for Aeroservoelastic Reusable Launch Vehicles

A Multifidelity Framework for Aerothermodynamic Modeling and Simulation of Destructive Atmospheric Entry

Discrete reconfigurable back-stepping attitude control of reentry hypersonic flight vehicle

Engineering methods for reentry prediction of uncontrolled spacecraft and space debris:the state of the art