Abstract:By using the transient finite element method, a three-dimensional wheelset-track coupled rolling contact model for high-speed rail is established, and the rationality and effectiveness of the model are verified by field measurements. Next, the wheel-rail contact stress states and relative slip characteristics are calculated and analyzed to reveal the cause of inner rail corrugation. Then, the vertical vibration acceleration of the rail/wheel is taken as the output variable to study the dynamic responses of the wheelset-track system. Finally, the parameter sensitivity analysis is carried out. The results show that the maximum normal/tangential contact stress between the inner wheel and inner rail is greater than that between outer wheel and outer rail due to the unbalanced load of inner rail caused by the excess superelevation of track structure, which indicates that the unbalanced load of the inner rail may aggravate the development of rail wear, and the rationality of the model established in this paper is verified. The wheel-rail relative slip region on the inner rail side appears periodically, and the distance between the two adjacent slip regions is close to the characteristic wavelength of the measured inner rail corrugation, which illustrates that the periodic variation of slip regions on the inner rail surface plays an important role in the formation of rail corrugation, and the validity of the model is verified. The periodic distribution of wheel-rail relative slip regions on the outer rail surface is not obvious, demonstrating that the outer rail tends to form uniform wear, which is consistent with the fact that the outer rail corrugation is slight in the measured section. The wheelset-track system has been in the process of unstable continuous oscillation in the analysis interval, combined with the analysis results of the wheel-rail relative slip characteristics, it can be concluded that the unstable self-excited vibration of wheelset-track system under the condition of tangential contact force reaching saturation is the main cause of rail corrugation. The dominant characteristic frequencies of vertical vibration accelerations of rail and wheel are all 561 Hz, the corresponding characteristic wavelength (148 mm) is close to the distance (150 mm) between the calculated adjacent slip regions, and is also close to the characteristic wavelengths (125 mm and 160 mm) of inner rail corrugation, which shows that the resonance phenomenon occurs in the wheelset-track system at the above frequency, thus leading to the increase of dynamic responses of wheelset-track system. The fastener vertical stiffness and wheel-rail coefficient of friction have significant effect on the development of rail corrugation, and the running speed determines the occurrence probability of inner/outer rail corrugation by affecting the track superelevation state.

Analysis of Influence Factors in Rail Corrugation on Sharp Curve of Metro

Trend analysis of rail corrugation on the metro based on wheel–rail stick-slip characteristics

Study on the formation mechanism of rail corrugation in small radius curves of metro

Theoretical investigation into the formation mechanism and mitigation measures of short pitch rail corrugation in resilient tracks of metros

Effect of Rail Pad Stiffness on Vehicle–Track Dynamic Interaction Excited by Rail Corrugation in Metro

Analysis of the causes of severe side wear of the high rail on metro curves by numerical simulation and field investigation

Study on the Mechanism of the Abnormal Phenomenon of Rail Corrugation in the Curve Interval of a Mountain City Metro

Analysis of rail corrugation characteristics based on PSD

An investigation into the mechanism of metro rail corrugation using experimental and theoretical methods

Study on the Effect of the Modeling Method of Railway Fastener on Rail Corrugation Prediction Model

Study on the effect of the fastener support structure on rail corrugation in metros based on the friction-induce vibration

Cause Analysis of Rail Corrugation in Metro Lines Based on System Vibration Characteristics

Study and Analysis on Rail Corrugation on Metro Lines

Investigation on rail corrugation grinding criterion based on coupled vehicle–track dynamics and rolling contact fatigue model

INFLUENCE OF WHEEL WEAR ON WHEEL-RAIL CONTACT BEHAVIOR AND DYNAMIC PERFORMANCE OF METRO VEHICLE

Study on the Formation Mechanism for High Rail Corrugation

Formation Mechanism of Metro Rail Corrugation Based on Wheel–Rail Stick–Slip Behaviors

Mechanism research and influence parameter analysis of rail corrugation of metro straight line track with steel spring floating slabs

Analysis of Rail Corrugation Characteristics on High-Speed Rail Based on Transient Finite Element Method

Study on the effect of mitigation strategies for rail corrugation in metro lines

Wheel/rail Contact Performance on Curved Track of High-speed EMU with Elastic Model