Abstract:Current dual-constellation GNSS navigation receiver can not fully satisfies the development of navigation industry. The architecture of current Compass and GPS dual-constellation navigation receiver is usually built upon FPGA and float-point DSP. Compared with fix-point DSP and FPGA, float-point DSP works slow and costs much, and it is also difficult to integrate float-point DSP into ASIC or ASSP. So in this paper, we discuss the optimized algorithm and the new implementation that integrate all parts of navigation receiver on one FPGA or ASIC.Our revised algorithm of navigation receiver is introduced first, mainly including acquisition and tracking mechanism. For acquisition module, we divide the whole acquisition process into three units: noise threshold detection, pre-acquisition, acquisition verification. For tracking module, with the help of accurate fix-point simulation, float-point variables are converted to fix-point ones, and rescaling is applied during all process to assure precision.Algorithm only makes sense when it combines with implementation, and the quality of algorithm also should be tested by application. So we also introduce the implementation of navigation receiver baseband algorithm on FPGA platform, including platform architecture, module division, work flow, and some optimization mechanics including resource sharing, process combination and etc. And we simply introduce the measure result and the application of dual-constellation navigation receiver baseband processor.And viterbi decoder for navigation receiver is also discussed. This paper brings forward a revised mechanism of viterbi decoder especially for navigation receiver. We borrow the soft output viterbi algorithm, but do not adopt the algebra ring method, and put forward revised viterbi mechanics. And the optimization is also on shorten-decoding, survival-path combination, butterfly calculation of ACS unit.

Design of system for high performance navigation computer system base on dual DSPs & FPGA

Design of navigation computer based on DSP & FPGA

The Integrated Navigation System of Auv "Xuanwu"

Design and Implementation of Visual Processing System Based on FPGA

Design of Navigation System Based on Dual DSP and FPGA

Design of VxWorks-based High-performance Embedded Control Platform

Design of Distributed Navigation Computer System Based on PC104 & DSP

Research of Parallel Strapdown Inertial Navigation Algorithm for High Dynamic Conditions

Research of high speed image processing system based on FPGA

Multi-axis motion control system based on DSP and FPGA

Development of signal processing system based on DSP and FPGA

A Novel Single Chip Implementation of MEMS INS Data Acquisition and Processing System Using FPGA and Its Soft Processors

The Optimization of Algorithm and Implementation for Dual-Constellation Navigation Receiver

Development of multisensor integrated navigation system based on distributed multiprocessor

Design of Visual Inspection System Based on DSP and USB Interface

Design of Re-Configurable On-Chip Navigation Computer Based on FPGA

Design of Multi-serial Communication for Flight Controlling Computer Based on FPGA

Design and Implementation of FPGA Based High-Speed Bus for Control System

An Intelligent and Acceleration ASIC Design for High Precision Positioning and Posture Surveillance System.

Design of infrared guidance control information data processing system based on dual DSP chips

Design and Simulation of JTIDS/BA/INS/GPS Navigation Processor Software