Abstract:Introduction Cardiac pacing has been an effective treatment in the management of patients with bradyarrhythmia and tachyarrhythmia. Different pacemaker location has different responses, and pacemaker effectiveness to each individual can also be different. A novel image-based ventricle animal modeling approach was proposed to optimize ventricular pacemaker site for better cardiac outcome. Method One health female adult pig (weight 42.5 kg) was used to make a pacing animal model with different ventricle pacing locations. Ventricle surface electric signal, blood pressure and echo image were acquired 15 min after the pacemaker was implanted. Echo-based left ventricle fluid-structure interaction models were constructed to perform ventricle function analysis and investigate impact of pacemaker location on cardiac outcome. With the measured electric signal map from the pig associated with the actual pacemaker site, electric potential conduction of myocardium was modeled by material stiffening and softening in our model, with stiffening simulating contraction and softening simulating relaxation. Ventricle model without pacemaker (NP model) and three ventricle models with the following pacemaker locations were simulated: right ventricular apex (RVA model), posterior interventricular septum (PIVS model) and right ventricular outflow tract (RVOT model). Since higher peak flow velocity, flow shear stress (FSS), ventricle stress and strain are linked to better cardiac function, those data were collected for model comparisons. Results At the peak of filling, velocity magnitude, FSS, stress and strain for RVOT and PIVS models were 13%, 45%, 18%, 13% and 5%, 30%, 10%, 5% higher than NP model, respectively. At the peak of ejection, velocity magnitude, FSS, stress and strain for RVOT and PIVS models were 50%, 44%, 54%, 59% and 23%, 36%, 39%, 53% higher than NP model, respectively. RVA model had lower velocity, FSS, stress and strain than NP model. RVOT model had higher peak flow velocity and stress/strain than PIVS model. It indicated RVOT pacemaker site may be the best location. Conclusion This preliminary study indicated that RVOT model had the best performance among the four models compared. This modeling approach could be used as “virtual surgery” to try various pacemaker locations and avoid risky and dangerous surgical experiments on real patients.

The Design of an Adjustable Animal_using Cardiac Pacemaker

A Study of Mechanical Optimization Strategy for Cardiac Resynchronization Therapy Based on an Electromechanical Model

Design Of A Remote Manipulative Cardiac Pacemaker

The rate-adaptive response study of integrated sensor pacemakers

Cardiac Pacemaker Survey-Twenty Hospitals Pacemaker Implantation Registry in China

Design and Experimental Testing of a Heart Assist Device with Pulsatile Flow Pump

A Battery‐ and Leadless Heart‐Worn Pacemaker Strategy

The Overview of Rate-adaptation in Cardiac Pacemakers

Fully Implantable Wireless Cardiac Pacing and Sensing System Integrated with Hydrogel Electrodes

Self-powered pacemaker based on all-in-one flexible piezoelectric nanogenerator

A Method to Realize Rate-adaptive Function in Pacemakers Based on Accelerometer Sensors

A self-powered intracardiac pacemaker in swine model

Design Of Cardiac Pacemaker Based On Embedded Systems

Optimization of Left Ventricle Pace Maker Location Using Echo-Based Fluid-Structure Interaction Models

Inductively powered wireless pacing via a miniature pacemaker and remote stimulation control system

Direct Powering a Real Cardiac Pacemaker by Natural Energy of a Heartbeat.

In Vivo Intravascular Pacing Using a Wireless Microscale Stimulator

In vitro testing of an intra-ventricular assist device.

An FPGA-based design for power efficient low delay rate adaptive pacemaker using accelerometer and heart rate sensor

[A Wireless Implantable Stimulating and ECG Monitoring System for Animal Models of Chronic Atrial Fibrillation].

A PMOS-based Programmable Stimulator with Adaptive Charge Pump for Cardiac Pacemakers