Abstract:Liquid crystal (LC) based devices such as displays, spatial light modulators (SLM) and different switchable phase masks constitute the main part of the graphic information display and light control. Mechanical rubbing and photo-alignment are the most widely used industrial technologies to create anisotropic surfaces for these devices. Recently, nonlinear laser lithography (NLL) was introduced as a fast, cost effective method for large area nano-grating fabrication based on laser-induced periodic surface structuring [1]. Here we report on alignment of nematic LC on NLL treated Ti film deposited on glass for the first time. We demonstrate controllable changes of azimuthal anchoring energy (AAE) depending on processing and additional coating parameters. To create the large area of structured Ti layers we used the experimental scheme of the NLL method, as described in [2]. The setup consists of a home-made femtosecond fiber laser system (up to 1.8 μJ pulse energy at 1 MHz repetition rate), galvanometer-scanner and motorized 3D–translation stage. The samples were 300 nm Ti films deposited on glass. 5×5 mm2 zones were structured by raster scanning of the laser beam over the surface with different parameters. To measure the twist angle and further calculate the AAE we have made combined twist LC cells. LC cells consisted of the tested and reference substrates where the last one was a glass substrate coated with a polyimide PI2555 and processed by the rubbing technique. The first type of the tested substrate was coated with Ti layer and further processed by the NLL method. The second type of the tested substrate was additionally coated with ODAPI. The twist angle was measured by using the combined twist LC cell method. Later, the AAE was calculated from the obtained twist angles of different samples. Fig. 1 (a-c) demonstrates dependencies of the measured twist angles and calculated AAE for different samples. We obtain controllable changes of the anchoring energy in the range between 2×10-6 J/m2 to 10-4 J/m2. The highest AAE 10-4 J/m2 is obtained for the samples which are processed by NLL with post-coating by ODAPI.

Alignment of Liquid Crystal Molecules in a Micro-Cell Fabricated by Femtosecond Laser

P‐56: Aligning Liquid Crystals Using Self‐Assembled Monolayers

P-56 / A . Murauski P-56 : Aligning Liquid Crystals Using Self-Assembled Monolayers

Fabrication of A Liquid Crystal Light Modulator by Use of Femtosecond-Laser-Induced Nanoripples

Femtosecond Laser Direct Writing of High-Q Microresonators in Glass and Crystals

Fabrication of Optical Cavities with Femtosecond Laser Pulses

Liquid-Crystal Photoalignment by Super Thin Azo Dye Layer

Laser micro-nano manufacturing technology for liquid crystal microdroplets with diverse inner structures

Investigations of the Mechanism of Liquid-Crystal Alignment on Rubbed Polyimide Films

Substrate Patterning For Liquid Crystal Alignment By Optical Interference

Alignment of Liquid Crystals on the Polymer Films Made by Pulsed Laser Ablation

Alignment and Actuation of Liquid Crystals via 3D Confinement and Two-Photon Laser Printing

Fabrication of Liquid Crystal Gratings Based on Photoalignment Technology

Liquid Crystal Alignment on the Patterns Produced by Nonlinear Laser Lithography

The alignment of nematic liquid crystal by the Ti layer processed by nonlinear laser lithography

Re-Writable Multi-Domain Liquid Crystal Alignment Layers Through Laser-Induced Micropatterning

Liquid Crystal Alignment on Polyimide Surface with Laser-induced Periodic Surface Microgroove

Surface Relief Gratings Used As Liquid Crystal Alignment Layer

Multi-domain liquid crystal alignment layers by erasable and rewritable laser-induced periodic surface structures

3D Microstructures of Liquid Crystal Networks with Programmed Voxelated Director Fields

Cost-effective photolithography-based dual liquid crystal alignment for versatile electro-optic applications