Abstract:Membrane biofouling represents a major challenge ever-present in the practical application of polyamide (PA) thin-film composite (TFC) reverse osmosis (RO) membranes. This work focused on grafting polyacrylamide (PAAm) onto PA-TFC via an in-situ atomic transfer radical polymerization (ATRP) method to improve the biofouling resistance of PA-TFC. The ATRP initiators, isobutyryl bromide (iPB), were introduced into PA matrix using a bifunctional small molecule, 2-bromoisobutyryl bromide (BIBB), added in organic hexane solutions to participate in interfacial polymerization through the condensation reaction with m-phenylenediamine. The successful introduction of iPB was confirmed by membrane surface characterizations, and the iPB density in PA layer was tuned by varying the BIBB concentrations in hexane solutions based on the variation in water permeance and salt rejections of iPB-loaded PA-TFC. The ATRP for the gradual growth of PAAm brush was thus in-situ achieved on the PA-TFC surface from the pre-incorporated iPB groups and the length of PAAm chains was facilely controlled via tuning ATRP polymerization time. The PAAm grafted PA-TFC exhibited a minimum decrement of water permeance and essentially retained salt rejections relative to the un-grafted ones. More importantly, the grafted membranes presented synergistically enhanced anti-adhesion and bacteriostatic performance towards either Gram-negative Escherichia coli (E. coli) or Gram-positive Bacillus subtilis (B. subtilis). Also, the grafted membranes presented a lower final flux decline ratio (FDRf) and higher final flux recovery ratio (FRRf) in relation with the un-grafted membranes in the dynamic bovine serum albumin (BSA) fouling test. Particularly, the membrane grafted with longer PAAm chains from extended grafting time showed better anti-biofouling performance: the sterilization ratio towards E. coli and B. subtilis achieved up to 98.8% and 99.0%, respectively, and FDRf of just 3.7% and FRRf of 97.6% after 3 × 8 h BSA fouling test for the membrane subjected to 2 h ATRP grafting. The PAAm grafting induced greater water wettability of membrane surface and the flexible chain structure of PAAm were proposed to account for the enhanced anti-adhesion and bacteriostasis towards bacteria, which collaboratively led to the improved biofouling resistance.

A Novel Method of Surface Modification on Thin-Film Composite Reverse Osmosis Membrane by Grafting Poly(Ethylene Glycol)

Surface immobilization of polymer brushes onto porous poly(vinylidene fluoride) membrane by electron beam to improve the hydrophilicity and fouling resistance

Poly(vinylidene Fluoride) with Grafted Poly(ethylene Glycol) Side Chains Via the RAFT-Mediated Process and Pore Size Control of the Copolymer Membranes

Improving the Hydrophilicity of Poly(vinylidene Fluoride) Porous Membranes by Electron Beam Initiated Surface Grafting of AA/SSS Binary Monomers

Grafting Techniques of Poly(ethylene Glycol) and Its Application in Membrane Surface Chemical Modification

Surface modification on thin-film composite reverse osmosis membrane by cation complexation for antifouling

Synthesis of an Amphiphilic Glucose‐carrying Graft Copolymer and Its Use for Membrane Surface Modification

Enhancing the Permeability and Anti-Fouling Properties of a Polyamide Thin-Film Composite Reverse Osmosis Membrane Via Surface Grafting of L-Lysine

Synthesis, Characterization and Anti-Fouling Properties of Poly(ethylene Glycol) Grafted Poly(vinylidene Fluoride) Copolymer Membranes

Antifouling and Antioxidant Properties of PVDF Membrane Modified with Polyethylene Glycol Methacrylate and Propyl Gallate

Surface Modification of Polypropylene Microfiltration Membrane by Grafting Poly(sulfobetaine Methacrylate) and Poly(ethylene Glycol): Oxidative Stability and Antifouling Capability

Synthesis, characterization and anti-foulingproperties of poly (ethylene glycol) grafted poly (vinylidenefluoride) copolymer membranes

Antifouling Poly(Vinylidene Fluoride) Microporous Membranes Prepared Via Plasma-Induced Surface Grafting of Poly(Ethylene Glycol)

Improving Hydrophilicity and Protein Antifouling of Electrospun Poly(vinylidenefluoride-Hexafluoropropylene) Nanofiber Membranes

Controlled Grafting from Poly(Vinylidene Fluoride) Microfiltration Membranes Via Reverse Atom Transfer Radical Polymerization and Antifouling Properties

Fabrication of Anti‐fouling Thin‐film Composite Reverse Osmosis Membrane Via Constructing Heterogeneous Wettability Surface

Polyvinylamine-grafted Polyamide Reverse Osmosis Membrane with Improved Antifouling Property

Surface Modification Of Microporous Polypropylene Membranes By Plasma-Induced Graft Polymerization Of Alpha-Allyl Glucoside

Antifouling and Flux Enhancement of Reverse Osmosis Membrane by Grafting Poly (3-Sulfopropyl Methacrylate) Brushes.

Immersion in Advanced Oxidation Water Followed by AGET-ATRP to Develop Low-Fouling Microfiltration Membranes by Grafting Poly(2-methoxyethyl Acrylate)

Improving the biofouling resistance of polyamide thin-film composite membrane via grafting polyacrylamide brush on the surface by in-situ atomic transfer radical polymerization