Abstract:It is well known that the hydrodynamics of dense gas–particle flows depends heavily on inter-particle and particle–wall collisions; however, the subtleties of these interactions are not always fully recognized or appreciated. In this study, the two-fluid model is used to systematically examine the effects of collision parameters, i.e., particle–particle restitution coefficient, particle–wall restitution coefficient, and wall specularity coefficient, on simulations of the hydrodynamics of a pseudo two-dimensional bubbling fluidized bed. The utilization of high-resolution Eulerian simulations facilitates the representation of meso-scale structures without the use of a sub-grid scale model, while qualitatively reflecting the experimental data. To ensure statistically robust results and increase confidence in the simulations, a careful assessment of the time-averaging interval was first undertaken to smooth out the fluctuations that persist even after the bed reaches steady state. A quantitative analysis was then performed to analyze important facets of the flow, including bubble characteristics, particle velocity fields, and granular temperature. The underlying physical formulation was employed to elucidate how collision parameters impact the hydrodynamics of the flow. The notable findings of this study are threefold. First, the specific details of the collisions between particles are shown to significantly influence the bubble characteristics and overall flow pattern. However, the effect of the particle–particle restitution coefficient turns out to be minimal on the bed circulation time except in the limit of particle elastic collisions. It is also found that the elastic collision of particles highly affects the bubble count and unexpectedly changes the role of the wall from a source to a sink of granular temperature. Second, the effect of the particle–wall restitution coefficient is appreciable on the granular temperature while having a minimal effect on the flow hydrodynamics. Third, the effect of the wall specularity coefficient is felt across the bed such that an increase in this parameter increases the bed circulation time. The results of this systematic study enhance the understanding of how collision parameters impact flow characteristics while also providing insight into the selection of their values in simulations.

Influential factor analysis of the bubble-particle collision efficiency in the contact zone of dissolved air flotation

A model for bubble- particle collision in the contact zone of dissolved air flotation

Experimental Investigation of Electrostatic Effect on Bubble Behaviors in Gas-Solid Fluidized Bed

Three-dimensional simulation of the influence of different flotation media in the dissolved air flotation tank through the population balance model

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Dynamic Modelling of Fluidisation in Gas-Solid Bubbling Fluidised Beds

Experimental Investigation of Electrostatic Effect on Particle Motions in Gas-Solid Fluidized Beds

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Cfd-Dem Investigation of Particle Elutriation with Electrostatic Effects in Gas-Solid Fluidized Beds

Effects of influent physicochemical characteristics on air dissolution, bubble size and rise velocity in dissolved air flotation: A review

Application of a simplified model for assessing particle removal in dissolved air flotation (DAF) systems: Experimental verification at laboratory and full-scale level

Interactions between flocs and bubbles in the separation zone of dissolved air flotation system

Study on the operation performance and floc adhesion mechanism of dissolved air flotation equipment

Numerical investigation on mixing behaviour in the contact zone of an industrial‐scale dissolved air flotation tank

Parameters of Collision and Adhesion Process Between a Rising Bubble and Quartz in Long-Chain Amine Solution and Their Correlation with Flotation

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Research on factors affecting bubble and particle behavior in a three-phase flotation system based on COMSOL

Numerical Investigation on the Dynamic Flow Pattern in a New Wastewater Treatment System

Effect of micro-bubble size and dynamic characteristics on oil removal efficiency of the flotation

The effect of collision parameters on the 3D Eulerian simulation of a thin rectangular bubbling fluidized bed

Investigations of bubble size distribution on swirl effervescent atomizer flotation